- Joined
- Mar 9, 2019
- Messages
- 33
- Motherboard
- Gigabyte Z390 UD
- CPU
- i7-9700K
- Graphics
- HD 630
After installed High Sierra, I used Multibeast for post installations. In Bootloader Section of Multibeast, I chose "Clover UEFI Boot Mode + Emulated NVRAM" and build and installed.
However, when I came to Boot Screen (Clover), Systems counts from 3 , 2 ,1 and then apple logo appears but nothing happens. I could not find a solution. I also used "Clover Configurator" but was unable to fix this boot issue.
I also attached my config.plist under my hard disk EFI > Clover. Could you please help me?
My system is:
Motherboard:Gigabyte Z68-D3-B3
Graphics: Asus GeForce GT430 1 GB
HDD: Segate 1 TB Barracuda 7200 RPM
RAM: 4GB
Monitor: Samsung 27"
Internet: I use usb adaptor TP-Link (works, no problem with it)
Stucks on this screen and does not open:
However, when I came to Boot Screen (Clover), Systems counts from 3 , 2 ,1 and then apple logo appears but nothing happens. I could not find a solution. I also used "Clover Configurator" but was unable to fix this boot issue.
I also attached my config.plist under my hard disk EFI > Clover. Could you please help me?
My system is:
Motherboard:Gigabyte Z68-D3-B3
Graphics: Asus GeForce GT430 1 GB
HDD: Segate 1 TB Barracuda 7200 RPM
RAM: 4GB
Monitor: Samsung 27"
Internet: I use usb adaptor TP-Link (works, no problem with it)
Stucks on this screen and does not open: