- Joined
- Jan 13, 2010
- Messages
- 7
- Mac
- Classic Mac
- Mobile Phone
Hello,
I followed Tony's guide for installing OSX with a Snow Leopard CD and the Cahmeleon boot disc. I follow his instructions and able to successfully install however once I reboot, the system loads and I see the blue screen it shows when the login prompt is about to show up. The blue screen flickers occasionally to a lighter shade of blue and it keeps doing this until it is powered off. When I add -x to boot into safe mode, the system loads fine. Is there a way to make it so I can boot normally?
Also, what are the differences between safe mode and normal mode? Can I still run the machine fully like I would in normal mode but under safe mode?
And where could I locate a kext for a realtek ACL889?
Thanks for everything,
-JoshT
I followed Tony's guide for installing OSX with a Snow Leopard CD and the Cahmeleon boot disc. I follow his instructions and able to successfully install however once I reboot, the system loads and I see the blue screen it shows when the login prompt is about to show up. The blue screen flickers occasionally to a lighter shade of blue and it keeps doing this until it is powered off. When I add -x to boot into safe mode, the system loads fine. Is there a way to make it so I can boot normally?
Also, what are the differences between safe mode and normal mode? Can I still run the machine fully like I would in normal mode but under safe mode?
And where could I locate a kext for a realtek ACL889?
Thanks for everything,
-JoshT