Contribute
Register

Broadwell i5-5675C + Intel GFX (Iris Pro 6200)

Status
Not open for further replies.
That is the primary symptom for a panic.
Just did not get any verbose output - like I do when it is panicking on boot with -v...

I have now been looking at the temperature - when running normally, I can start LuxMark a few times in a row - temperature going up after each run (IGPU only). Starts around 65°C, ends around 75°C. I then started to move windows etc, to also busy the processor - and bam...

Same happens after few seconds running LuxMark with both processor and IGPU...

I do actually have some Crashreporter stuff (possibly did not see it earlier) - its in /Library/Logs/CrashReporter.
What should I look at there?
Thanks...
 
95°C is when problems begin

What is there?
Screenshot 2019-01-25 at 21.01.00.png
 
CPU PM, not likely.
It does not make a difference whether its there or not...
Have you got any ideas? Should I restore 10.14.2 and see if the problem was there as well?
Running GeekBench is no problem (temperature does not rise much there, too).
What else could I try to challenge IGPU & processor - to see whether it is a load issue...
Or do you suspect a LuxMark bug? Shouldn't cause such panics...?
 
Status
Not open for further replies.
Back
Top