Contribute
Register

Boot loop after first stage of installation

Joined
Dec 18, 2019
Messages
17
Motherboard
Asus z170
CPU
i7-6700K
Graphics
Internal
Hi All,
I created a Big Sur USB installation drive by following the OpenCore tutorial by Dortania. Everything seems to go really smooth and I enter setup as I start the installation. When the screen hits '12 minutes remaining' it start to reboot (checked some youtube installation video and this seems to be normal). After the reboot it should pick up the setup again to finish the installation but instead it reboots and reboots and reboots. Is there something I missed or something I should double check in my settings?

BIOS SETTINGS

#Disabled​

  • Fast Boot
  • Secure Boot
  • Serial/COM Port
  • VT-d
  • CSM
  • Intel SGX
  • CFG Lock

#Enabled​

  • VT-x
  • Above 4G decoding
  • Hyper-Threading
  • Execute Disable Bit
  • EHCI/XHCI Hand-off
  • OS type: UEFI Mode
  • DVMT Pre-Allocated(iGPU Memory): 128MB
  • SATA Mode: AHCI
This is what I see when booting and it stops right here and getting rebooted:
IMG_1679.jpg
 

Attachments

  • IMG_1661.jpg
    IMG_1661.jpg
    3.6 MB · Views: 29
Last edited:
Top