- Joined
- Jan 8, 2019
- Messages
- 28
- Motherboard
- Gigabyte Z390 Master
- CPU
- i9-9900K
- Graphics
- RX 5700 XT
Ok. I was wondering if I should try that. I do that now.
Ok Slide =0 did not work either. I attached latest error log which ends with:
14:104 00:004 OCABC: MMIO devirt start
14:109 00:004 OCABC: MMIO devirt 0xE0000000 (0x10000 pages, 0x800000000000100D) skip 0
14:113 00:004 OCABC: MMIO devirt 0xFE000000 (0x11 pages, 0x8000000000000001) skip 0
14:117 00:004 OCABC: MMIO devirt 0xFEC00000 (0x1 pages, 0x8000000000000001) skip 0
14:121 00:004 OCABC: MMIO devirt 0xFEE00000 (0x1 pages, 0x8000000000000001) skip 0
14:125 00:004 OCABC: MMIO devirt 0xFF000000 (0x1000 pages, 0x800000000000100D) skip 0
14:130 00:004 OCABC: MMIO devirt end, saved 278604 KB
14:134 00:004 AAPL: [EB|#LOG:EXITBS:START] 2020-08-24T04:08:12
I have tried reseting and cleaning NVRam to no effect. Is there anything else I can try?
did you modify your Bios settings?
parallel port disabled,
Cfg unlocked, intel SGX
no secure boot. etc.
I had every kind of kernel panic until I found all the wrong bios settings
Also SIP must be disabled. in your config.plist IS enabled.
maybe try uploading your config.plist to:I disabled SIP, and had no of the BIOS issues you listed. Still same kernel panic
Ok. Here is the Config. I'll put into sanity checker but it is 0.6.1 now. The output says I need one more Protocol Override. But when you look at my config there are 18 now due to it being 0.6.1. I checked my 0.6.0 version and it is all ok with sanity checker so I believe there is no issue with this one either.maybe try uploading your config.plist to: