Contribute
Register

BCM4352 Airport Failure after Wake

Status
Not open for further replies.
Joined
Jul 2, 2015
Messages
19
Mac
  1. 0
Classic Mac
  1. 0
Mobile Phone
  1. 0
Problem:
I have a XPS 13 9343. Currently running El Capitan. Most of the features are working, including wifi and bluetooth. However, after wake, airport becomes inactive and cannot be turned on unless I restart my computer.

Followed these threads by Rehabman:
Installation: http://www.tonymacx86.com/threads/guide-booting-the-os-x-installer-on-laptops-with-clover.148093/
Patch: http://www.tonymacx86.com/threads/guide-patching-laptop-dsdt-ssdts.152573/

@RehabMan, thank you!
Attached is my IOReg, Clover/EFI, and the 2 command line outputs, as requested.
 

Attachments

  • B.zip
    2.3 MB · Views: 57
Problem:
I have a XPS 13 9343. Currently running El Capitan. Most of the features are working, including wifi and bluetooth. However, after wake, airport becomes inactive and cannot be turned on unless I restart my computer.

Followed these threads by Rehabman:
Installation: http://www.tonymacx86.com/threads/guide-booting-the-os-x-installer-on-laptops-with-clover.148093/
Patch: http://www.tonymacx86.com/threads/guide-patching-laptop-dsdt-ssdts.152573/

@RehabMan, thank you!
Attached is my IOReg, Clover/EFI, and the 2 command line outputs, as requested.

ACPI is not patched correctly.

http://www.tonymacx86.com/threads/guide-patching-laptop-dsdt-ssdts.152573/
 

I followed this guide again as close as possible. But the problem is still there.
Interestingly, I think it might be because that I accidentally added a kext for Brcm_4360. Airport is in conflict because there are 2 drivers. I outputted my console before and after the wake in the attached file.

Do you think this might solve the problem? Could you let me know how to remove brcm_4360 since I have brcm_4352. Thank you!
 

Attachments

  • airport_error.txt
    1.9 KB · Views: 114
Last edited:
I followed this guide again as close as possible. But the problem is still there.
Interestingly, I think it might be because that I accidentally added a kext for Brcm_4360. Airport is in conflict because there are 2 drivers. I outputted my console before and after the wake in the attached file.

Do you think this might solve the problem? Could you let me know how to remove brcm_4360 since I have brcm_4352. Thank you!

If you have an issue/question with ACPI patching, it is off-topic here. You should open a separate thread in the appropriate laptop forum.
 
Status
Not open for further replies.
Back
Top