Contribute
Register

<< Solved >> BCM43142A0 is recognised but doesn't work

Status
Not open for further replies.
Joined
Oct 13, 2019
Messages
6
Motherboard
Dell Latitude E7440
CPU
i3 4000M
Graphics
HD 4600
Hey,
I installed macOS Mojave on my Laptop recently. Everything works fine except the WiFi (Broadcom BCM43142A0). It is recognised in the USB-Section of my System Report but doesn't work. Any Idea?
Screenshot 2019-11-17 at 21.39.58.png
 
Try with BrcmPatchRAM. If it's supported and you are lucky, it will work
 
Try with BrcmPatchRAM. If it's supported and you are lucky, it will work
Is there anything to set up because it doesn't work by just installing it. Any other ideas?
 
Is there anything to set up because it doesn't work by just installing it. Any other ideas?

I just saw the BrcmPatchRAM3 config and your model and ID is listed.
Try installing BrcmPatchRAM3+BrcmFirmwareData+BrcmBluetoothInjector in your "Other" kexts folder in EFI/CLOVER.

An SSDT for the USB ports is needed in order to configure it as internal device and avoid sleep/wake loops. However it's detected so for it should work.
 
I tried it but it didn't worked. Is there anything I should configure in my config.plist in order to get it work? Thanks for helping
 
I tried it but it didn't worked. Is there anything I should configure in my config.plist in order to get it work? Thanks for helping

I don't think so.. you should check if your Clover is updated and post some logs..
 
Yes, my Clover is completely up to date. Where can I find my Clover Log?
 
Status
Not open for further replies.
Back
Top