Contribute
Register

Asus XG-C100C 10GBase-T PCIe Network Adapter

Status
Not open for further replies.
Joined
Sep 16, 2012
Messages
182
Motherboard
Asus Z390M-Pro TUF Gaming
CPU
i5-9400
Graphics
RX 5600 xt
macOS 10.13.2 contains a driver for some Aquantia devices, because the iMac Pro will use that Ethernet chip. You might want to give it a try. :)
 
I have one on order. It would be nice if someone makes a kext out of linux source.

Does this card work now in 10.13.3?
 
Yes it does work in 10.13.3. Perfectly.

OK thanks! I owe you one. I ordered three. Fingers crossed.
 
OK thanks! I owe you one. I ordered three. Fingers crossed.

I received my cards today, they work OOTB as promised.

I've been holding off on upgrading my Sonnet Presto Gigabit PCIe Pro systems to High Sierra. Now I'll just swap them out for an Asus XG-C100C.

Thanks again!
 
Anyone get this these to work on 10.13.5? Im thinking i might need to rebuild my hackintosh.
 
Also need help here... just installed it. Windows is working fine. Mac does not recognise, and can't find a way to make it work on network prefs. Anyone? Please?

running 10.13.4
 
Last edited:
Is there a way to extract a copy of the firmware (perhaps using ethtool under ubuntu?).
I am running 10.13.4 and own an ASUS Rampage VI Extreme which has AQC107 onboard.
It was disabled when I install High Sierra as I already owned an Intel PRO 1000 PT Dual Port Adapter which is natively supported OOB.
Just wondering if I can get this bonus 10GbE support from my mobo.
 
You need a correct clover kext to patch entry which enables flashed Apple-AQC cards in High Sierra 10.13.4+

2fFPaGQ.png


Thanks... meanwhile i found the solution, forget to mention it here before. Than you!
 
Hello, could you please confirm:
- there is no throttle problems with it ?
- once its firmware has been updated under 10.13.3, there is no way to use it after under Windows 10 (dual-boot) ?
EDIT: I found BootCamp drivers for question #2
Thanks.
 
Last edited:
Status
Not open for further replies.
Back
Top