P1LGRIM
Moderator
- Joined
- Mar 2, 2012
- Messages
- 26,455
- Motherboard
- Lenovo ThinkStation p700
- CPU
- 2x E5-2620 V3
- Graphics
- RX 560
- Mac
- Classic Mac
- Mobile Phone
With a UEFI capable board you should use UEFI mode not Legacy.Where am I doing wrong?
With a UEFI capable board you should use UEFI mode not Legacy.Where am I doing wrong?
I don't understand in which step I use legacy. I create the USBInstaller following the guide and using EFI Clover tool. After this step in my USBInstaller there is the EFI Folder where I then replace the file according to the guide. Where am I doing wrong?With a UEFI capable board you should use UEFI mode not Legacy.
Hello. I have followed all the instructions but I get stuck on "AppleACPICPU" when installing.
Im using OsxAptioFixDrvAre you using OsxAptioFixDrv2? if so use OsxAptioFixDrv instead.