Contribute
Register

Asus Rampage V Extreme - Mac OS X El Capitan 10.11.5 Installation Guide

Status
Not open for further replies.
With a UEFI capable board you should use UEFI mode not Legacy.
I don't understand in which step I use legacy. I create the USBInstaller following the guide and using EFI Clover tool. After this step in my USBInstaller there is the EFI Folder where I then replace the file according to the guide. Where am I doing wrong?
Probably the error condition is when installing on my PC?
thank you.
regards
 
Hello. I have followed all the instructions but I get stuck on "AppleACPICPU" when installing.
 
Hello. I have followed all the instructions but I get stuck on "AppleACPICPU" when installing.

Are you using OsxAptioFixDrv2? if so use OsxAptioFixDrv instead.
 
OK. Now Im confused. Is it inside EFI/EFI that I put the Files or El Capitan/EFI
 
It gets stuck in this part. Pic attached. 1st and 2nd try.
 

Attachments

  • IMG_0073.JPG
    IMG_0073.JPG
    3.7 MB · Views: 181
  • IMG_0074.JPG
    IMG_0074.JPG
    1 MB · Views: 119
Last edited:
I got it to install OS X. After Reboot installing graphics web driver had the same problem. What helped boot normal was enabeling CStates & PStates.
 
the only problem that i have right now is. No Bluetooth, No Audio and the USB 2.0/3.0 onboard.
 
Finally I have everything working 100%. My concern now is the Geek Benchmark. Is it normal. Please see attached snap.
 

Attachments

  • Screen Shot 2016-12-14 at 11.27.08 AM.png
    Screen Shot 2016-12-14 at 11.27.08 AM.png
    97 KB · Views: 292
Status
Not open for further replies.
Back
Top