Each time that you install/update Clover it copies your previous configuration to your system drive in /EFI-Backups, you should be able to find your old config.plist there.Hey, somehow my Clover's config got messed up.
i5 6500
16gb DDR4
DW1560
Does anyone have a config.plist I could borrow?
Hey, somehow my Clover's config got messed up.
i5 6500
16gb DDR4
DW1560
Does anyone have a config.plist I could borrow?
Thank you for your reply.I have just installed Sierra with a i5-7500 after upgrading to the 7.00 BIOS. Memory speed is 2400 according to the BIOS and Sierra. Of course, you must upgrade the BIOS using a supported sky lake CPU first.
Thank you for your reply.
Were you able to install using the 7.00 BIOS or did you first install with the 1.41 BIOS and then upgrade your BIOS to 7.00?
I guess I can contact the seller of the Deskmini 110 to see if it has version 1.50 or 7.00 of the BIOS before I purchase the motherboard. (I don't have access to a Skylake processor.)
can you share some detail? thanksI have just installed Sierra with a i5-7500 after upgrading to the 7.00 BIOS. Memory speed is 2400 according to the BIOS and Sierra. Of course, you must upgrade the BIOS using a supported sky lake CPU first.
Since the serial ports being enabled by default was causing Mac OS X installation to fail, did they instead provide an option to disable serial ports in the BIOS? Just curious.Yes I was able to skip the previous versions, I upgraded from 1.10 to 7.00 directly. All the changes from the previous versions should be included in the last one, including macOS and kabylake support
Since the serial ports being enabled by default was causing Mac OS X installation to fail, did they instead provide an option to disable serial ports in the BIOS? Just curious.
After updating the BIOS version >= 1.50 using some compatible sky lake CPU, just follow this guide:can you share some detail? thanks
Hey guys! Just a little update. I managed to install osx and got it up and running! It works relatively fine. Thanks for the advice!
Setup:
- Lan/Sound/M2 (500gb Samsung Evo 960)
- Bios version 7.00
- 8gb 2400 mhz
- 7600 CPU
I have two issues. One is that OSX randomly freezes every now and then. The computer requires a full restart to start working again. I have searched through the forum, but couldn't find a solution so far. I think the problem has to do with the LAN drivers, because it mainly happens during browsing and other ethernet requests. Anyone experienced something similar?
Secondly, I have problems installing my 16-gb ram module (Crucial Ballistix 16gb ddr4-2400). Once installed the computer (most of the time) boots into osx, but closes every program I open with an errors. Also it reboots every now and then and often crashes during bootup. I tried different configurations in the config.plist file to get it working, but no luck so far. Does anyone have any suggestions.
Attached is my Clover folder