- Nov 9, 2017
- ASRock Z370M Pro4
- i5-8400 2.8 GHz
- Radeon RX580 8GB
- Mobile Phone
Missed Post #1/Installation: ....Select one method, remove before installing another method; 2 methods installed, no audio possible
Missed Post #1/Support: see IV. Problem Reporting
Missed Post #1/IX. Unsupported/Non-working AppleHDA Realtek Audio - 100/200 Series
Audio ID: 2 is not correct for your motherboard, use 1
Post to one of the Problem Reporting threads, off topic.
I'm sorry if I followed the instructions the wrong way. I was told to by you to follow Post #2 (see attached image).
It was a new installation. I had not done anything audio-related until now.
But now that I have audio in this condition (outputs and inputs show up in system preferences but nothing plays), if I understand correctly, I will need to remove any previous work before trying again, correct?
If so, I can certainly remove the AppleALC.kext from the EFI>CLOVER>kexts>Other folder, and roll back the config.plist to where it was before, when the install was clean (no audio adjustments at all)
But how do I roll back the changes that were made by running the "audio_cloverALC-130_v0.3.command" in Terminal?
Or can I keep those and then start again after just rolling back the config.plist and removing the AppleALC.kext?
This one seem pretty confusing to me. My brain's ability to parse the instructions may not be there, who knows, but keep encountering conflicting information, so I think I'm just following the wrong instructions.
128.4 KB Views: 160