Contribute
Register

Acer Aspire 5742 Stuck before UniBeast Maverick 10.9.4 installation

Status
Not open for further replies.
Joined
Jun 23, 2014
Messages
1
Motherboard
Intel
CPU
Intel Core i3-370M
Graphics
Intel HD Graphics
Mac
  1. 0
Classic Mac
  1. 0
Mobile Phone
  1. 0
Hay guys!
My UniBeast installer stuck before installation starts.
I am using Acer Aspire 5742 PC,its spec is
Intel Core i3-370 processor
Intel HD Graphics
6GB DDR3 RAM
640 GB Hard Disk
I used a VMware to make the bootable USB drive nd it was successfully done but just after start up the logo Chang to black screen and it stuck. I have tried every boot flag that I know and taught that work but non does.
I have attached below z last message displayed in verbose mode before turning to black.
 
Hay guys!
My UniBeast installer stuck before installation starts.
I am using Acer Aspire 5742 PC,its spec is
Intel Core i3-370 processor
Intel HD Graphics
6GB DDR3 RAM
640 GB Hard Disk
I used a VMware to make the bootable USB drive nd it was successfully done but just after start up the logo Chang to black screen and it stuck. I have tried every boot flag that I know and taught that work but non does.
I have attached below z last message displayed in verbose mode before turning to black.

gen1 Intel HD graphics are not really supported. At least not without some hacking. See: http://www.insanelymac.com/forum/topic/286092-guide-1st-generation-intel-hd-graphics-qeci/
 
Status
Not open for further replies.
Back
Top