Greetings!
Created a bootable flash drive using this manual - https://www.tonymacx86.com/threads/unibeast-install-macos-high-sierra-on-any-supported-intel-based-pc.235474/
+ in addition, I added SATA-100-series-unsupported.kext, SATA-200-series-unsupported.kext and AHCIPortInjector.kext
In...
Greetings,
I have been running my hackintosh trouble free for a few years now. On my primary hackintosh I run a dual boot of Mojave (upgraded stupidly assuming web drivers were just around the corner as always) and windows 10 on the same HDD. I know its not the most efficient but I had installed...
Hi folks,
Searched a lot but no one quite seems to have this problem, at least from what I found --
Only my boot drive is showing up in system report / etc. External USB drives don't show; the other internal drive isn't showing either.
It was working just fine initially -- had it running for...
Hello everyone.
I am trying to install macos sierra on my dell inspiron 15 7559 laptop and I am following the guides below:
- guide 1
- guide 2
I am able to successfully launch the setup. The only problem I am facing right now is that the setup cannot detect my HDD. It just shows my clover...
Hello, I have a hakintosh since the month of February based on X99e and a cpu xeon e5 hexacore under sierra. It works very well, I had a ssd of 250go with windows I could go from windows to osx without problem. I decided to do without windows and use my USB boot keys with clover the same one...
Hi,
I have successfully got a pc put together and working.
Motherboard: Gigabyte Z270x-Ultra-Gaming
Processor: Intel Core i7-7700K
RAM: 16GB
Graphics: Using Intel Graphics for time-being
HardDrives: 1x Crucial 275GB MX300 SSD (fresh out the box), 1x Seagate Barracuda 1TB (fresh out the box)...
I recently dug out a old Seagate hard drive from a TV box that I had laying around. I just put it in and installed it (plugged in the cable but didn't turn it on. I turned on my computer and I received a error message saying it was unreadable, yet my bios settings are always set to read from my...
Hi,
Tried following this guide to do a fresh install of Sierra. I had chosen Legacy Boot option while creating Unibeast USB. Could boot from USB and install Sierra successfully. Restarts into Clover bootloader screen but my hard disk - where I have installed Sierra - is not shown in the hard...
I followed the instructions on the installation video to a tee. I try to boot up from the usb and it crashes after the apple logo appears.. I recently swapped a 60GB Patriot SATAHD for a WDC 640GB. The new HD is properly connected and shows up in the BIOS settings in AHCI mode, but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.