Search results

Boot with verbose mode to find out where the installer is stuck. -v as boot arg in clover. Then you could proceed. Also remove the AppleKeyAggregator-64.efi and AppleKeyFeeder-64.efi from drivers folder of Clover/EFI. They have been known to cause problem with latest build.

@RehabMan Any advice?

Thanks for the reply. The link is for PCIe devices however mine is USB2.0 CRW connected to USB3.0. I however did try the mentioned kext but it didn't work.

Hi me again. So I have got almost everything working on my Dell Vostro 3558 with Mojave 10.14.1 Lastly what remains is the SD Card. (Realtek USB 2.0 CRW). It is shown in System Report but the card is not mounted. What I tried- 1. AnySDCard.kext (changing the id everything) 2...

I have it in Clover/kext/other Do I need to put it in L/E as well?

I followed you advice. I tried with VodooPS2Controller with and without the VoodooI2C kexts. I got functional trackpad but a bit glitchy and some keyboard key maps were not working.eg Home, End etc. So I removed VoodooI2C kexts and installed AppleSmartPS2Touchpad.kext It works flawlessly. But...

I tried the steps you said (whatever I could understand) but the error still exists. Steps I did- 1. Replaced HDD with and SSD (now boots faster but the error that I mentioned in the first post still exists) 2. Rebuilt DSDT after replacing SSD Patches included Remove _DSM Brightness Fix Haswell...

Thanks for the reply. 1. I went through the guide and I reinstalled Clover from your fork. But the config.plist still shows the earlier settings. I am unable to fix the bad settings. 2. I installed the necessary kexts in either L/E or S/L/E and whichever was advised to be installed at...

I have successfully installed Mojave 10.14.1 on my Dell Vostro 3558 and almost everything is working (Replaced the Wifi card with BCM94352Z). The problem is that I have a very slow boot requiring more than 2 mins. I ran the command log show --predicate "processID == 0" --start $(date...

Thanks everyone for you help. What worked for me. 1. Realtek ALC 255 - AppleALC/Lilu in L/E and injecting layouts-id=7 and alc-layout-id=3 under Device/Properties 2. Synaptics Trackpad - ApplePS2SmartTouchpad.kext in L/E (Voodoo works partially) and Roollback Touchpad Prefpane from Sierra to...

Uploaded the required files

I had attached all the files that you mentioned in the given post in my OP. But I did that manually. Tell me those files are enough. Else I will upload the debug.zip file using the .sh file given later in the post in a few hours when I get back from duty.

Thanks @RehabMan for your prompt reply. I had gone through the post that you have mentioned and tried 1. AppleALC method+Lilu and inject layout 2 in config.plist under Devices/Properties. But no audio output devices detected. The kext output shows some error which I have uploaded in the text...

@RehabMan Can I have your attention to my post? Thanking you in anticipation.

Hi this is my first post on this forum. Please correct me if I make mistakes or break forum rules. I have successfully installed Mojave 10.4 on my Dell Vostro 3558 (Intel Corei3-4005U/Realtek ALC255/I2C-HID Touchpad Synaptics-Dell). Previously I was able to use I2C Trackpad and audio in High...

Did you get Intel HD 4000 full qe/ci working? If yes could you tell me how