IF something is not working during installation its because (maybe) you have a different graphic card.
Try to use bootflag: GraphicsEnabler=Yes or if its not working then "No"
Could you be more specific or clear.don't understand you.
Be advised that this forum is not meant for people who don't have an advanced understanding off hacking osx
Maybe you put the graphic card on a slow PCI port? there is not enough bandwidth?
Regarding sound you have to check the specs from the audio chip and only install the proper KEXT
Here is my step by step guide
Hope it will help the community
http://www.tonymacx86.com/mavericks-desktop-support/127373-maverick-intel-dx79sr-guide-step-step.html
After one week of trying, I finally successfully installed a fully working OSX Maverick on my Hackintosh.
Thanks for the help to other members of the forum.
To help the community, I am posting my step by step guide.
Install time (without the unibeast preparation) aprox. 35min
Tech. spec...
I solved all of the problems slightly differently from your suggestions.
my hackintosh is fully working
I will post a detailed description how I did it for all the users out there with the same motherboard.
if I understood correctly, standard procedure like I did, only add in MB voodoo kext, in chameleon wizard I should only check after MB do its job, the standard 0x2000 and dart=0, not anymore cpus=1, correct?
I forgot to mention that the CPU on the mother board is a Xeon 8 core if this makes a...
I just finished the procedure by your new instruction, i did not used chameleon wizard, just in case to be sure to not mess up with something.
I rebooted and manually entered again the ncpi=0x2000 dart=0
unfortunately no success :-(
here is the screenshot where it stopped:
hope that you have...
you have to have the installation of the OSX in the Application folder. there are many tutorials on the net (YT) also.
Multibeast when is installing it searches for the operating system in the Aplication folder, if it doesn't find it, it will give you that message
The audio chip is Realtek ALC892 NON DST
Great, thx for the help
What about chameleon wizard app? Should I use the screenshot settings from you thread or something else?
Anyway...
I followed your instructions (before you replied with this above)... and started a fresh install with no success...
Hi Stehor, great post.
I unfortunately came across your post too late :-(
So I would only ask you few things... (before I start a complete new installation of Maverick due to "bad" multi beast and Chameloen wizard settings)
Could you be so kind to see my post here...
I have a similar issue ( http://www.tonymacx86.com/general-help/127104-multibeast-wrong-settings-installed-way-avoid-complete-maverick-installation.html ).
Would it be possible to manually remove those problematic kexts if I mount the system disk in "offline mode" on another MAC?
If yes, where...
Tech. Spec.: INTEL DX79SR
http://www.intel.com/content/www/us/en/motherboards/desktop-motherboards/desktop-board-dx79sr.html
I have successfully installed 10.9.2, and went to do the final post-installation with multibeast v.6.2.1. (Maverick)
Before the final step to install the bootloader on...
@ DrTOM
How did you boot again after "fakeSMC" you noticed had problems?
I mean, did you remove manually the kext file? (If yes, how you did that)
Thanks for the answer
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.