Search results

Thank you very much! Initially, I was getting the same result with the new EFI - verbose mode was stuck at the same point. Did two things - used a different USB drive and checked my BIOS settings again, even though it seemed to boot into Clover fine with those settings. Strangely, things were...

@CaseySJ, Thank you for your reply. Hard to believe that this build is already so old - must be on Pandemic time :)

Had some issues with a previous installation. So I went back to my Mojave 10.14.6 backup. Pretty standard build. But I flashed the Thunderbolt EEPROM without issues and had been running it like this for quite some time. Followed the guide to replace Clover with OpenCore a number of times...

It seems like Security Update 2020-007 Mojave has fixed that annoying screen freeze that happens when you have UAD Software for Universal Audio interfaces installed. Please try it and report...

Like you, I was going to jump from Mojave to Catalina once. I thought a 5700XT would be an upgrade from my Vega 56. But it didn't perform as well as even my 56, so I suspect you may find it a disappointment after your 64...

Not sure if it is the issue here, but when I flashed my Z390 build I needed to do a hardware reset to my Apollo before it was recognized...

Thanks for the push. I shot some video while flashing the Thunderbolt of my Z390, but hadn't finished editing the process until today: https://youtu.be/4C9K52dG5Bw

First of all, thank you to @Inqnuam and @CaseySJ for fixing my issue. To help others who are moving from Clover to OpenCore while running Mojave and have flashed modified firmware to their Thunderbolt ROM, the steps that worked were: Add the SSDT-TB3-DROM-HOTPLUG.aml generated from Inqnuam's...

Thanks for the suggestion. Unlike oreoapple I did not have SSDT-TBOLT3-RP05-DESIGNARE-Z390.aml but I disabled SSDT-Z390-DESIGNARE-TB3HP-V4.aml with no change in the symptom.

OpenCore 0.6.0 finally booted for me under Mojave after CaseySJ posted the preparation steps about removing Hackintosh kexts. Thanks for that! Once it was booting I replaced the existing kext with IntelMausi.kext to fix the other Ethernet port. Then I copied the Inqnuam Thunderbolt DROM from my...

Did a clean install of Mojave recently after months of smooth operation on my Designare only to find the same long delay. Removed UAD Meter & Control Panel app and it's back to a quick boot with no long lag with only the cursor moving but otherwise unresponsive system. Software and firmware up...