@CaseySJ Hello! I have a new problem again.
The headphone jack on the front panel of my mainframe has no sound. The audio interface on the rear panel of the main unit has sound.
Is this normal?
@CaseySJ Help...
The system that was previously installed with the guide is perfectly compatible with Magic Mouse 2 and Magic Trackpad 2. They can be used normally without dropping.
But today I updated the things in your document above. I restarted and found that Magic Trackpad 2 failed. It...
I think I found a way for the time being. I changed SMBIOS to iMAC19, and then added -no_compat_check to boot-Arguments.
The no-go symbol no longer appears. The system starts up normally and recognizes. However, the cpu model still shows unknown.
I have modified the correspondence of the pins. Bluetooth is fully functional!
Also, please change my SMBIOS to iMAC19,1. A forbidden symbol has appeared. The -v mode appears as shown in the figure.
I have updated Clover to Clover_v2.4k_r4918. Is it still not possible to change to...
This is the device card I received. (picture from the seller)
He gave me a 3pin regular stitching line. Then he sent the following picture to me.
I can see a little bit of understanding. So I tried to insert it myself. Bluetooth can be recognized normally as shown below. I think it should...
Bluetooth is finally ready for use. It really is that I didn't connect the device card to the USB port.
The device card I purchased, the seller only gave me the line of three pins. He told me that the three pins correspond to the DM, DP, and NC interfaces of the usb port. I tried to connect and...
I think the problem should be that I am not connected to the USB port.
But this motherboard seems to have only one USB port? This port was plugged into the USB interface on the front of the chassis. If I want to plug in this Adapter Card. Does it mean that the USB interface in front of the...
Hello! @CaseySJ I have a new problem. I hope you can help me.
I purchased the wireless network card BCM94360CS2 and Adapter Card. Then I boot wifi can be used normally. But my Bluetooth is not showing up. I looked for a blue device in the device tree and it showed no information found. What is...
Hello everyone! I want to customize the value of Hardware UUID? Is it achievable?
If so, what should I do? Please tell me the specific steps.
thank you very much!
I will read your recommended article!
Thank you for your patience. I have benefited from reading your article. Thank you for sharing. Because you and I have implemented an almost perfect Mac system.
I am using an Apollo Twin Mk II Quad sound card.
I read the article @CaseySJ and installed it from start to finish. The sound card is in normal use and is very stable. Plugins can also be used normally.
I'm running 10.14.3 (18D109), too.
I have just tried it many times. I should overturn my reply to you.
The device-id is displayed as 923E0000. Because I did not cancel the Inject Intel in Graphics. Once I cancel it, the device-id will become 983E0000. I have to tick it to show what the picture...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.