Search results

Disable Thunderbolt, disabled Resizable Bar, Disable CSM. Opencore 098, add your serial.

@aol Set Secure Boot Model to Disabled

@UtterDisbelief gorgeous build! I just got the same case in black myself. Great job.

Wifi was definitely the first time I've felt "hacky" doing this to the point where I have disabled wifi completely and am fully on Ethernet. Fenvi is just a Bluetooth card now, for me. I don't like using OCLP either, though I understand why some might--I prefer not to touch macOS. Also, turns...

I read a lot of "why hackintosh" on forums. Here's why--I haven't had a single issue with this session. The slowest part is the initial opening or copying of an Acustica plugin but once on it's like anything else. I don't post a lot here, and that's because I'm very busy using the machine but I...

I went down that route as well but what confirmed it for me was when Monterey also didn't work with Wifi. To be honest, I'm not sure whey IGD (MSI call integrated graphics that) was enabled in the first place. Proabably was in a rush.

All good, thanks much. Still no joy, the only difference between ours seems to be the subsytem-id (0x111 or 0x133) but adding that as property does me no favors. No biggie, we'll get there. Good luck on the move. Fixed: In bios internal graphics needed to be disabled. Somehow that little bit...

@Edhawk could I grab of screenshot of your IOReg PXSX properties for you fenvi?

@Edhawk , fresh out of ideas. I wish I could force load this Monterey AirPortBrcmNIC.kext but im fresh out permissions nor can I unload the current version. https://github.com/dortania/OpenCore-Legacy-Patcher/pull/1077 Looks like I just wait a bit.

@Edhawk update. Also, I knew better than to leave off the last 00. For shame. When using A3430000 without the kext wifi still shows up but wont find networks, eventually disabling itself. When using A0430000 or BA430000 without the kext wifi shows up with "!" and will not work. When using any...

@Edhawk ok here's what i've tried so far and the results. I've tried: A04300 A34300 BA4300 With airportbrcmfixup enabled I will get a failed boot on all except A04300 (wifi shows with a "!"). Without the kext I get nothing. Is this user error?

Hopefully tomorrow morning.

Smart advice, I'm out of the studio today but will try that. I feel like we're zeroing in.

094 didn't correct anything. A lot of head scratching going on here. I did notice that our card types are slightly different. Perhaps its just patience thats in order.

All vanilla, nothing 3rd party or in LE, no intel WiFi/BT on the board. Will upgrade to 094 as a test in case something shifty happened there. It shows up in IOREG and all seems well but bad behavior. Im ok without but I am super curious to what caused it to fail.

I seem to be the oddball with bad wifi on 13.5. Driving me nuts.

Nada. I moved ports and confirmed that it (ports) will work with other devices. The BIOS is setup appropriately. Not sure what gives here. I can see it in IOReg, hackintool--all the places. Bluetooth works and wifi will occasionally see my iPhone hotspot but will not connect. I've tried a clean...

1. I've been back quite a few revisions--I'll need to look when I'm back at the studio today. 2. I cleared yesterday after disabling fixup. 3. 093. I'm going to perform a couple test today: Check slot Change slot

Don’t sweat it I’m home now and can dig it up.

@Edhawk if you have an old install of Ventura (13.1) could you pass me the native AirportBrcmNCIS.kext?