Hi All, I'm a bit lost here.
Would you please, help me to identify this Thunderbolt EX3 card version? I've tried both FW NVM18 and NVM26, but the card doesn't appear in the IOService list. Do I need to jump a header on this version too? Please suggest pins.
After I got Asus X299 Deluxe fully working with Thunderboltex 3 I've realized I want to move forward and replaced it with two-port card.
I've already ordered GC Alpine Ridge Ver 2.0 and I've been reading that I need to burn EPROM with GC-Titan-Ridge-V2.0-Mod-NVM50-CaseySJ.bin. I understand I...
Problem is solved. This particular board is working fine under NVM26. My mistake was in the typo opencore aml path that I previously missed. Thank you!
I've tried all Alpine Ridge based, no luck so far. The one from Gigabyte sees external enclosure, but doesn't see the device inside it.
Would you suggest if those settings are correct for X299 BIOS?
Hi, would you please help to identify version of Asus Thunderbolt3 EX card and proper firmware to upload? I tried both AlpineRidgeEX3-NVM18-NATA and AlpineRidgeEX3-NVM26-NATA together with SSDT-TBOLT3-RP21-ASUS-TB-EX3.aml and in both cases TB3 card is detected, however any device connected is...
Seems, I found an interesting thing - did High Sierra dropped a support for the SATA controller integrated into Skull Canyon's PCH?
Look on two screenshots - one is Sierra and High Sierra. NUC6i7KYK is loaded with two SATA SSDs. One sees that, another doesn't
If I replace one with NVMe Intel...
Please, find all BIOS screenshots attached. I tried same process with High Sierra yesterday and failed again. So, I'll stay in this thread as my problem exists for both. I used USB 3.0 and 2.0 sticks. Please, suggest.
I posted Verbose photo and EFI earlier: https://www.tonymacx86.com/threads/guide-intel-skylake-nuc6-and-skull-canyon-using-clover-uefi-nuc6i5syk-nuc6i7kyk-etc.207848/page-79#post-1585638
See BIOS50 configuration file attached.
Hope, that helps!
Would you mind please sharing your BIOS version and a configuration? I'm with NUC6i7KYK and I can't get Sierra installer running. I posted it few pages earlier that I always stuck at the beginning of the install with ++++++.
I'm on BIOS 50 and for now that's the only difference to RehabMan's...
unfortunately I can't downgrade mine to 48, as it's not supported.
I have another last idea except BIOS - this NUC is currently connected to 4k screen, I'll replace it. at least for the installation.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.