Question about the M2A_CPU Connector on a Z590i Vision D
I know it only works with a 11th gen CPU for a NVMeE drive.
But will it work to use the slot for a BCM94360CS2 with M.2 A/E adapter?
@CaseySJ @ori69
Hi @CaseySJ Here's the logfile
One question: since where' in a different timezone (Europe) its really hard to react fast.
If possible would you be so kind to work on this a little bit earlier so i can act faster.
Its ok if this is not possible.i appreciate all the work and effort you put in...
Nah, I think I will stick to Gigabyte ..the MSI 490i Unify gave us headache remember:banghead:
Lets hope Gigabyte comes with a BIOS update soon:-)
My EFI is really basic
I only did the USB part.
It seems the one from @ori69 actually Works now.
The only thing I did is replaced it with my...
Hi @CaseySJ
I tried @ori69 EFI and had some problems with the USB and my TB equipment didnt show up.
Weird since ori has it working on his system.
I managed to make my own USB Patch,and now thunderbolt shows as expected.(No Hotplug yet,I tried the Mapple Ridge patch from you)
Here some files...
Thank You.
-It seems Linux sees it as USB, check screenshot.
- Before boot Apollo & TB enclosure works! :cool:
- I tried your SSDT-TB3HP-JHL8540-MAPLE-RIDGE (No hot plug )
Tomorrow I start with USB configuration
Thanks
. 99% Sure there is no firmware chip at the back of the board (Attached a pick from the back)
Near the TB controller there are no 8 pins chips (Bottom with the silver plate there's the TB connection)
. I use the SOIC8 clip with Arceli USB-based CH341a programmer,Clip is right attached with dot...
@CaseySJ
The TB controller was hard to find at the back of the board.
After further inspection Gigabyte decided to put the Winbond Chip under the IO/Cover at the front of the board.
I also noticed there are 2 controller chips MXIC MX (Marked as 1) & Winbond (Marked as 2)
I tried to extract the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.