Hello,
My laptop really confuses to go into sleep mode. When I put to sleep, the screen does turn off, the harddisk also but it doesn't go to really sleep mode (lights on, fan still spinning). I really don't know how to solve this.
At system bootup, when I search for AGPM in Console it gives me for about 500 times this message: "12/07/15 21:56:36,000 kernel[0]: AGPM: updateGPUHwPstate(0, 0): fHwPstate = 0 fFB = 0xffffff800e4ef800".Then a few times switching from g-state to ..... mixed with previous message. And then, it...
No only mbp 6,2 is patched with my VendorDevice.
At system bootup, when I search for AGPM it gives me for about 500 times this message: "12/07/15 21:56:36,000 kernel[0]: AGPM: updateGPUHwPstate(0, 0): fHwPstate = 0 fFB = 0xffffff800e4ef800".
Then a few times switching from g-state to ...
Hello,
After hours getting AGPM.kext loading, I was surprised by the fact it doesn't change my gpu's frequency. HWMonitor says so, and I think it's true because it is still running quite hot. It's changing G-States properly, according to Console.
I attached my AGPM.kext and IOReg. I'm using...
Even though console shows changes, I think the gpu isn't clocking down. HWMonitor says so, but my gpu isn't getting colder also, so I'm afraid HWMonitor is the boss right now. Any thoughts?
Yes you can change log-control(in AGPM.kext/info.plist) to 1 then it shows changes in console. I know enough. THANKS FOR YOUR HELP REHABMAN!!:headbang:
After fresh install, it loaded. BUT HWmonitor says that my frequency is 405 MHz, don't matter which g-state I am. Console log is switching, but my frequency isn't. Which one is right? Is it switching or not?
Yes I know, but which values should I use in AGPM.kext? I tried near everything but the kext does't load at all.
Should I use "Mac-F22589C8" or "MacBookPro6,1" as identifier?
Should I use "Vendor10deDevice0a6c"(id of my GPU) or "GFX0" because I changed it so in DSDT.
The guide I used to install the whole system said that I had to remove IOPlatformPluginFamily.kext. I installed it again, from installer stick. If I'm not mistaken ACPI_SMC_PlatformPlugin.kext is inside that kext. But my AGPM.kext says no.
Should I use "Mac-F22589C8" or "MacBookPro6,1"?
Should...
I changed it to GFX0(see IOreg) but it still doesn't work. Could you check if I have good value's in my AGPM.kext? I checked it with plutil, it's ok but maybe my vendor/device aren't correct.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.