Glad to hear about your success!
The Dortania Guide is excellent, from the 6.3 even more understandable than before - and with the necessary tools linked.
I just updated to 11.1 without problems.
It takes about half an hour after a 3.6GB download.
I would recommend to follow the Dortania USB guide. Its very comprehensive.
I tried and failed to do the mapping twice - but as this guide got updated, I finally succeeded.
Its roughly these steps:
1. use USBInjectAll to get all the USB ports.
2. route the ports EHC1 to EH01 and EHC2 to EH02...
Updated to Big Sur 11.0.1
Open Core 6.4
New to OC, used pre-compiled Haswell AMLs. Sleep does not work.
Just mapped USB ports and made a custom USBmapping.kext - that now works well.
Its an old build ... but with 32GB RAM and NVME patch for the BIOS - It works quite nice.
The 960 EVO shows as internal on my Mojave setup, and I don't remember addressing this issue in my Clover setup.
The Catalina-Data partition shows under "Locations" in Mojave finder sidebar,
and I can't remove it from there.
Mojave works very well with Clover.
I also installed Catalina on second boot drive - it works, but I rather wait till next . update so that the iCloud and Mail issues are resolved. Catalina looks quite a nice update.
I don't perceive any significant differences in boot speed between Mojave and Catalina.
Not sure what you mean by stops in between.
Run Catalina install in a Mojave boot - install into a fresh new APFS drive - Reboot.
Select OSX install in Clover - reboot.
Updated to Catalina.
Updated Clover and all kext beforehand.
The install only worked from Mohave onto a new drive WITHOUT any other (HFS) partitions.
My EFI Clover setup failed to load Catalina Install from a USB drive.
Thank you tsrattan for sharing your EFI folder.
I tried to simply replace it with mine, as the config.plist was a bit too complex for me to understand and to apply it to my setup. I went back to FakeSMC.kext... but the system did not boot up at all.
Does your system go to sleep properly?
Are you still using this setup?
I am trying to do some tweaks to it under Mojave, but the excellent thread from Wildwillow does not see much attention anymore. So I am wondering if I might get lucky here...
With latest Clover from main branch and kexts to go in Library/Extensions.
Please be sure to remove all other kexts, expecially since VirtualSMC.kext is used.
drivers64UEFI of clover contains also:
DataHubDxe-64.efi (not sure about function, system works without)
FSInject-64.efi (not sure about...
I got USB 3.0 running again on all ports.
Switched to VirtualSMC.kext in the wibe of "modern and lean" system - works fine so far.
All it takes are 6 kexts and a minimal config.plist.
I have deepest respect from all the developers - thank you so much!
I tried to create a custom USBPorts.kext...
I attempted a vanilla installation of Mohave 10.14.2 and realized that I could not get the system running via MultiBeast with the same ease as it was the case on earlier systems and ended up "hacking" together a system from old EFI folder, which left me with slight unease.
Then I tried...
Sorry to hear about this.
I made sure the cables are in the correct direction.
I had initial issues with Bluetooth, because I was using the old dongle as well at the same time.
I had no USB keyboard or mouse, so I tried to delete the device from the system, remove the dongle and then wait for...