My laptop really confuses to go into sleep mode. When I put to sleep, the screen does turn off, the harddisk also but it doesn't go to really sleep mode (lights on, fan still spinning). I really don't know how to solve this.
At system bootup, when I search for AGPM in Console it gives me for about 500 times this message: "12/07/15 21:56:36,000 kernel: AGPM: updateGPUHwPstate(0, 0): fHwPstate = 0 fFB = 0xffffff800e4ef800".Then a few times switching from g-state to ..... mixed with previous message. And then, it...
No only mbp 6,2 is patched with my VendorDevice.
At system bootup, when I search for AGPM it gives me for about 500 times this message: "12/07/15 21:56:36,000 kernel: AGPM: updateGPUHwPstate(0, 0): fHwPstate = 0 fFB = 0xffffff800e4ef800".
Then a few times switching from g-state to ...
After hours getting AGPM.kext loading, I was surprised by the fact it doesn't change my gpu's frequency. HWMonitor says so, and I think it's true because it is still running quite hot. It's changing G-States properly, according to Console.
I attached my AGPM.kext and IOReg. I'm using...
After fresh install, it loaded. BUT HWmonitor says that my frequency is 405 MHz, don't matter which g-state I am. Console log is switching, but my frequency isn't. Which one is right? Is it switching or not?
Yes I know, but which values should I use in AGPM.kext? I tried near everything but the kext does't load at all.
Should I use "Mac-F22589C8" or "MacBookPro6,1" as identifier?
Should I use "Vendor10deDevice0a6c"(id of my GPU) or "GFX0" because I changed it so in DSDT.
The guide I used to install the whole system said that I had to remove IOPlatformPluginFamily.kext. I installed it again, from installer stick. If I'm not mistaken ACPI_SMC_PlatformPlugin.kext is inside that kext. But my AGPM.kext says no.
Should I use "Mac-F22589C8" or "MacBookPro6,1"?