Yes, I've try it and when you connect YOUBO, no other Bluetooth devices connected, then Sleep doesn't work.
And Yes, YOUBO is connected to 1x PCIe slot (only one at Vision-D).
And last Yes :), I've Fenvi card still ... (now I've switched it back) ...
Thank you @CaseySJ for reply.
- after unplug all ext & internal USB Sleep works
- after reconnect all ext & internal USB excluding new YOUBO PC Hackintosh WiFi Card BCM94360CD Sleep works
It means that source of Sleep issue is YOUBO card itself. What do you think, better use old-one Fenvi...
Please, could you help me with Wifi installation?
I've new: YOUBO PC Hackintosh WiFi Card BCM94360CD [Amazon: link].
For better sleep/wake up. Now after installation, when computer sleeps, immediately wake ups.
What I've try:
- unplug all USB devices
- internal USB connector from Wifi card...
do you anybody here have issue with Netflix + Safari 14? (Latest Catalina 10.15.7 + OpenCore 0.6.1)
Apple TV+ works, Netflix at Chrome works but Safari, when media comes to play, sends me to help page,
for installation correct version HTML5 or Silverlight player (Netflix Error...
Especially I've same issue as you describes in point 2) Sleep problem ...
Helps only hard-reset of system, then everything comes back in normal.
Previous OpenCore was in this OK, I suppose that is something in latest changes ...
I've LG monitor, DP cable, DP 1.2 enabled.
New BIOS for Vision-D is now at Gigabyte page: BIOS . F5a works - sure after setup CFG lock again. Everything is fine from my perspective. Some BIOS options like XHCI Hand-off are now near to configuration needed for Hackintosh.
Hi, you can try use set of Kexts from my EFI (based on work of @CaseySJ) ; EFI.Z490.Vision.D ...
Build on OpenCore 0.5.9 ... all Kext versions you can check at GitHub homepage.
I've very same issue .... I was need WhateverGreen 1.4+
For me works:
- showdown all system
- put GPU to slot PCIEX16
- remove Motherboard battery for 30 seconds approx.
- connect your monitor to GPU (don't use internal Thunderbold or HDMI Motherboard connectors)
- let system goes up (several restarts happens)
- screen should display BIOS (use DEL or...
Thank you for all care @CaseySJ ...
I found this Solution !!! Use BIOS Settings → IOPorts → Thunderbolt → Thunderbold Boot Support to value: Boot once.
Now Apollo x8p works after restart without turn on/off !!!
WAW, Tip #1 help, simply shutdown it all and carefully reconnect :)
@CaseySJ Thank you very much ...
BUT after next restart is situation again same ... works only:
- Shutdown Mac
- Switch Off UAD
- UAD On
- Mac Start
- UAD Control Panel connects as normal ...
I'm using SSDT-TB3HP.aml from...
I've issue with Thunderbold 3 device: Universal Audio Apollo x8p ; after reset it doesn't detect device by UAD Meter & Control Panel. When I switch it off/on, it runs?
Any suggestions or experience with this? Thank you ...