- Joined
- May 24, 2013
- Messages
- 10
- Motherboard
- Gigabyte Z490 UD
- CPU
- i7-10700K
- Graphics
- GT 710
- Mac
- Mobile Phone
Hi All.
I made a Hackintosh 10.8.3 a few years back, didn't use it much but now I need to, problem is, I'm totally out of the Hackintosh loop and I have a glitch I need to sort. When starting up I have to hold down F12 to get into the Gigabyte motherboard screen, where I have to choose the USB stick that I prepared with Unibeast, from a list of potential boot devices. I hit return, then after a few seconds I get another choice of boot discs with the USB tomato logo (Chimera?), at this point I choose my internal boot disc and all is good. At this point all 3 monitors are working. If I let the comp start up on its own, I only get one monitor. I suspect that I screwed up the installation a couple of years back, then stuck it on the shelf. Any pointers?
Thanks.
Vid card:ATI radeon 5770
MB: Gigabyte ga-z77x-ud5h
I made a Hackintosh 10.8.3 a few years back, didn't use it much but now I need to, problem is, I'm totally out of the Hackintosh loop and I have a glitch I need to sort. When starting up I have to hold down F12 to get into the Gigabyte motherboard screen, where I have to choose the USB stick that I prepared with Unibeast, from a list of potential boot devices. I hit return, then after a few seconds I get another choice of boot discs with the USB tomato logo (Chimera?), at this point I choose my internal boot disc and all is good. At this point all 3 monitors are working. If I let the comp start up on its own, I only get one monitor. I suspect that I screwed up the installation a couple of years back, then stuck it on the shelf. Any pointers?
Thanks.
Vid card:ATI radeon 5770
MB: Gigabyte ga-z77x-ud5h