Recent content by zev23

Q: Why are you using dGPU during installation process? A: I think USB Installer boot successfully but end up no signal from iGPU to monitor before finding out the connector type patch in Hackintool. To use Hackintool I need a working macOS which I'm still building. Therefore I've no choice but...

zev23's Build Gigabyte H370 Aorus Gaming 3 WiFi + Intel UHD 630 Components Intel i7-8700K Processor Gigabyte H370 Aorus Gaming 3 Wifi Intel AC9560 WiFi (included with motherboard) (A dGPU already in my system and using it while installation. Not use once Sonoma fully setup) Installation...

Hi Blurnabe, can you share your working clover folder (config.plist, kexts folder, driver64efi folder...)? I think remove the theme folder and zip it will be alright to upload here. Also do you still keep Intel 9560 on the mobo or take it out? Thanks.

Think its about time for me to investigate Black Friday/Cyber Monday Deals ;) Thanks for the help.

Yes quite old, C2Q ICH10 hardware. The USB ports on the board are all USB2.0/1.1. For example the logitech webcam i have will run at USB 2.0 bus no matter which port i plug into; the USB bluetooth always shows under USB bus regardless which port it use. I have removed the eltima driver (USB...

Hi RehabMan, please check the attachment as requested.

I have a USB bluetooth which is detected as below: BCM20702A0: Product ID: 0x21ec Vendor ID: 0x0a5c (Broadcom Corp.) Version: 1.12 Serial Number: 001986001B7F Speed: Up to 12 Mb/sec Manufacturer: Broadcom Corp Location ID: 0x3a100000 / 1 Current Available (mA): 500 Extra...