Hello, the RX480 is working correctly in Windows.
But I can't see the boot screen when I boot up. So I can't select a boot device without switching cables first. I believe this has something to do with the IGPU setting in BIOS.
Thanks again for taking the time to help me.
I have Windows 10 installed (UEFI) and on a different Hard Disk. And I set the graphics device in my BIOS to IGPU, otherwise it doesn't boot in to Sierra.
The way it works now is, I turn on my computer and I see nothing until it I see the login...
Thanks, here are the screenshots.
Screen Shot 2017-05-19 At 15.19.10 by vblinden posted May 19, 2017 at 9:20 AMScreen Shot 2017-05-19 At 15.18.58 by vblinden posted May 19, 2017 at 9:20 AMScreen Shot 2017-05-19 At 15.18.43 by vblinden posted May 19, 2017 at 9:20 AMScreen Shot 2017-05-19 At...
I got it working. For the audio I used the AppleALC. And with the RX 480 I forgot to set the graphics device to IGPU. But now if I want to boot to Windows, I have to switch the monitor cable to the on board card to select an other boot device.
Is there any way to fix this? Or should I open a...
First of all, thanks for taking the time to help me. I succeeded in booting in to Sierra successfully, everything is working OK (even if I don't run Multibeast, everything is good. Except graphics and audio). When I try to install the ACL892 and the 100 series via Multibeast and reboot, audio is...
Hello all, first time that I try to make my computer a Hackintosh.
I am running in some trouble with the configuration of my system. The specs of my current setup are listed below.
Motherboard
Gigabyte GA-B150-HD3P
Processor
Intel Core i5-6500
Memory
Crucial DDR4-2133 - 8GB * 2 (16GB in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.