Recent content by tsanko.dimitrov

macOS 13.4 with OC 0.9.2, no TB SSDT and BIOS F8 -> no TB hot plug. Tested with Apple TB2 Ethernet device via TB3 to TB2 adapter. It's visible on cold boot only.

@loopatic Above 4G Decoding must be turned on, but the GPU Resizable Bar option can be turned off for now. All other settings seems to be correct.

Update 04.04.2023 Updated to macOS Ventura 13.3, OC 0.9.1 and all the kexts as well. Full EFI uploaded.

You need to know some things first before you really want to start: Read carefully your MB user manual - hardware part Set your SATA controller to AHCI SATA mode, macOS does not support RAID Disable resizable BAR if you don't know how to configure this in OC Before you start the installation...

Post your EFI to review it and please make some screenshots of your BIOS settings so I can be able to check you did everything correctly.

Remove the -x boot flag and put -v only.

Hi, @Smallersen , my system is based on 11th gen 11700K CPU. The CPUFriend.kext is using the data provided in CPUFrienDataProvider.kext and this data is generated especially for my CPU. It's not compatible for your 10th gen CPU. As your CPU is natively supported, these two kexts are not...

Ok, good luck and if a kernel panic occur, try to make a screenshot to see what's the problem is.

This configuration is not valid - it's not my last modified. There are a lot of kexts included, most of them are not necessary and some device properties are not needed. I don't know how to help...

This EFI archive is corrupted. Can't be opened.

In my opinion in your system is Secure Boot active or there are some keys deployed. Try to boot into BIOS, enable the secure boot and remove all deployed keys. Post a screenshot with the kernel panic information. Well, the CPU is supported on Z490 and Z590. The problem is not in your CPU, the...

If you have access to a mac device (a MacBook for example) open the attached config.plist with OpenCoreConfigurator and open the PlatformInfo tab on left. Near the Model Lookup there is a combobox listing all the Apple device models. Select MacPro7,1 and OCC will automatically generate the data...

No, generate them before the installation. One last thing. Install the macOS on a separate NVMe/SSD drive, not on a partition. If you plan to use Windows 11 dual boot, it's better to use one NVme/SSD drive for macOS and another for Windows. Do not install them both on same drive. If you have...

Yes, you need to generate UUID, Serial and MLB. This values are a MUST.

Nothing else you need - remove this values and the kext. gibMacOS is OK. Put a smaller monitor if there is any, but I believe the 4K resolution is supported from your GPU out of the box.