Recent content by Torock

  1. Torock

    XCPM Problem with Haswell-EP E5-2660 v3

    Hi everyone, i was able to install Mojave on this System: CPU: Intel Xeon E5-2660 v3 Board: Asus X99-A II Grafic: Asus RX570 Everything works quite well except XCPM. For installation I used this guide...
  2. Torock

    iMac Pro X99 - Live the Future now with macOS 10.14 Mojave [Successful Build/Extended Guide]

    Ok thank you I will see if I can find someone with my CPU. Thank you anyway for your help
  3. Torock

    iMac Pro X99 - Live the Future now with macOS 10.14 Mojave [Successful Build/Extended Guide]

    I made the adjustments. But with activated Haswell-e bootstrap, the system does not boot anymore. IMG_8595 by Torock posted Dec 1, 2018 at 10:43 AM Without the bootstrap the system starte up but has same issue as before. By means cpu runs at boost frequence I flashed the BIOS by using the...
  4. Torock

    iMac Pro X99 - Live the Future now with macOS 10.14 Mojave [Successful Build/Extended Guide]

    Sorry for bad information.I added my EFI Folder, dsdt.aml, an export of ioreg and the bios setting for cpu powermanagement. I hope this is more helpful.
  5. Torock

    iMac Pro X99 - Live the Future now with macOS 10.14 Mojave [Successful Build/Extended Guide]

    I tried to implement this Haswell-EP bootstrap but no success... Config.plist by Torock posted Nov 30, 2018 at 5:44 PM I also added xcpm_cpuid_set_info but the system didn't boot. I also double checked the Bios Settings but there is no difference to your guide
  6. Torock

    iMac Pro X99 - Live the Future now with macOS 10.14 Mojave [Successful Build/Extended Guide]

    Hi kgp, first of all thanks for this great guide. It works almost fine on my system. At the moment i have one issue: My CPU runs in idle at 75W and 50 degrees. I configured XCMP the same way like your guide says. But every time I check with "sysctl machdep.xcpm.mode" the return is 0. Do...
Top