Recent content by T1hom7as

Hey nice guide M1D1MAN098. Good to see that this laptop is still going ha :)

Depends how you boot OS X. But you could do this for the file names: - bootmgfw.efi = Windows 8.1 - bootmgfw-orig = Windows 10. Then Clover should notice the two OS's. EDIT: You will need the two different bootmgfw.efi files from Win10 and 8.1.

Boot in verbose mode (-v) and then you can see where the problem lies. Are kexts installed in /Extra?

Try this: nv_disable=1

Few things... You have UEFI mode available, so why don't you use Clover? If not and you still want to use Unibeast, then try turning off your NVIDIA card off in the BIOS. Also try these: - IGPEnabler=Yes with - IGPlaformID=01660003 EDIT: Also input your specs into your profile...

Post full specs.

FakePCIID: BCM577XX as BCM57765 [Testers Required!] Attached:

FakePCIID: BCM577XX as BCM57765 [Testers Required!] IMO just clears things up a bit.

FakePCIID: BCM577XX as BCM57765 [Testers Required!] Still looks the same. All tests are done with the Clover DSDT patches FixLAN_2000. But the only difference is injecting the PCI information. When this is resolved, would you be able to implement a Clover patch on the fly/FakeID patch so...

http://www.tonymacx86.com/yosemite-laptop-support/147567-guide-patching-kernel-haswell-cpus-xcpm-early-reboot.html

You should be using a MacBookPro9,1 SMBIOS. As it will be after pre-2011 it should then boot with the black screen.

You can install with Unibeast if you wish, but Clover will most likely give you the best features and compatibility of your laptop. The guide is not too extensive, you only need to read it and use the parts which you need. The reason it is long is to make sure everyone understands correctly...

FakePCIID: BCM577XX as BCM57765 [Testers Required!] I have BCM57785 and was using a Kext (attached) which injected the NIC, however never actually tested. Both the kext and your FakePCIID's show the NIC, but the kext that I was already using looks like it injects better (cosmetically). As I...

Suggest maybe reading here first: http://www.tonymacx86.com/mavericks-laptop-support/112684-acer-aspire-5750g-mavericks-10-9-clover-install-guide.html

Have you injected kexts into /EFI/CLOVER/kexts/Other and/or /EFI/CLOVER/kexts/10.10???