Recent content by SuperheroRobot

sorry. I think I got it I use this -> https://www.tonymacx86.com/resources/efi-mounter-v3-1.447/

Just to be clear, you are being helpful UtterDisbelief. It's been a while, how to I find the EFI folder on my drive again?

So what could that mean? if the only drive connected didn't have a EFI folder and clover installed but still the Catalina installer never loaded?

yesterday I removed different hard drives while trying to start the install, the results were all the same. Even when the only hard drive connected was the one that had Windows.

I have a clone on another drive. Do you think it would be worth it to boot up into that clone and erase my main drive?

I have tried safe mode, it had the same result. I do have a macOS installed. The destination disk currently has High Sierra, and it has drivers for a NVidia GPU. I confirmed the BIOS settings. Also, I've been using this Hackintosh since late 2016. I can't use the Catalina installer because it...

Hi, I did as you described. Yes I used UniBeast to create the installer and I'm using Clover.

Hi, I have a hackentosh running High Sierra. I replaced my 1080 ti with a 5700 xt and am attempting to do a clean install of Catalina. I'm following these instructions -> https://www.tonymacx86.com/threads/...alina-on-any-supported-intel-based-pc.285366/ I'm stuck at STEP 4: Install macOS...

The progress bar never moved beyond about 40% so I canceled it. Does anyone have any ideas?

I tried with the GPU installed and removed all Boot Args except for agdpmod=pikera. That had the same result, Catalina doesn't load. I tried with the GPU uninstalled and with Boot Args: dart=0 nv_disable=1 agdpmod=pikera. This time the Apple logo showed and the progress bar seem to get stuck...

I tried booting with agdpmod=pikera with the RX 5700 XT installed. Should I try with the GPU not installed?

I tried with Boot Args: dart=0 nv_disable=1 agdpmod=pikera... and this had the same result, Catalina installer never loads and restarts. dart=0 nv_disable=1 are there by default. Should I remove them?

I set the BIOS to use the integrated GPU, removed the 1080 so no GPUs were installed. The machine did start up, however the result is the same. The Catalina installer never shows up, Apple logo shows with progress bar, then the machine restarts.

I removed the RX 5700 XT and tried starting the machine without a GPU installed. The machine would not boot up, gave 5 beeps. I installed the GTX 1080 Ti, and the result is the same, Apple logo displays with progress bar, then it restarts. The Catalina installer never loads.

The machine wont start up without a GPU. It gives 5 beeps. I think this is a known issue with the motherboard. Should I try installing Catalina with the 1080 attached?