Some updates: sold my Kingston V300 SSD because of performance issues (maximum sequential writes were up to 100 MB/s and reads up to 160 MB/s). Bought Samsung 840 EVO 120GB, difference in speed is insane :) Benchmark attached in the 1st post.
Hi, I have no issues after waking up from sleep. Did you try using only one monitor or just pulling out the signal cables and connecting back without turning off?
Actually the problem is firmware, not the Blackmagic Disk Speed Test. Check here: http://www.anandtech.com/show/7763/an-update-to-kingston-ssdnow-v300-a-switch-to-slower-micron-nand
You may try updating the firmware using a Windows machine. Instructions and firmware can be downloaded from here...
Good question indeed! I just followed some youtube videos showing how to configure BIOS on Z87, but as you asked this, I set now XHCI to Enabled and boot up perfectly. According to this thread...
Thanks! Indeed my configuration is the same, so I've reinstalled everything, managed to run installer with native monitor resolution and after that there have been no problems related with booting or integrated graphics :)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.