Changed.
For now it´s working, thanks everyone, you´re f***ing great!!!
I noticed something, this C6 is enabled when I boot and look into Clover options, but when I go to the config.plist it isn´t? Is it ok? Can I do anything else to optimize the computer?
Ok, I manually changed those so I´ll leave them as USB3 connector.
I exported and Hackintool generated several files, should I do anything with the others?
Checked again with the USB3 hub:
Back ports 5 and 6 (USB3) only work as USB2. Back port 8 (USB2) doesn´t work at all.
Even if I change the connector type (column), this disappears when I restart, but the comment remains.
I have a hub that says USB3 but I think it´s fake, no matter where I connect it, Hackintool says it´s USB2...
EDIT: It was my fault, I had connected the mouse and keyboard in the hub. I disconnected them and tried again and Hackintosh shows the USB2 and USB3 ports used. Except for the back 5...
Ok, removed the USBPorts.kext from /CLOVER/kexts/Other and from /System/Library/Extensions
USBInjectAll.kext was in /CLOVER/kexts/Other.
I activated all port limit patches that were in Clover.
SSDT-EHCx_OFF.aml was already there.
Restarted and checked. This is the result:
Now I can see 4...
Yes, I followed the guide, but I have several patches in Clover and I don´t know if the one I used is the right one and if the USBInjectAll worked.
I opened the chassis and saw that one connection from the top USBs (from the chassis) wasn´t well connected so I changed it to the other slot (the...
Ok, I copied the USBInjectAll.kext into the Clover/kexts/Other folder.
Then I restarted and opened config.plist with Clover. Then I enabled "com.apple.iokit.IOUSBHostFamily" (83FB3F0F), see screenshots. Is this ok?
Then I checked the USB ports one by one, with a USB 2.0 MIDI controller and...
Hi Edhawk, I installed the most recent version of Hackintool and now I have info in the USB tab. Here you have the log attached, and I copied the SSDT-EHCx_OFF.aml file into that folder.
Now I´ll restart and upload a new boot log and the info I have, and proceed with the port configuration.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.