Recent content by rsleonard

Sorry, in advance, for my newbie questions: I'm just looking for a little guidance on your post: 1. What format is the bootable USB Flash drive 2. When you say "reboot from your primary drive" I assume you mean your MacOS drive?

Just confirmed -- based upon NewEgg listing...it is the GA-170N-WIFI

Anybody out there with any anecdotal information regarding the Corsair Bulldog High Performance Barebone . It is a prepackaged package that comes with Intel Gigabyte Z170N-WiFi Motherboard w/ USB 3.0 Type-C and 802.11ac Wi-Fi. Looks to be similar to Gigabyte GIGABYTE GA-Z170N-WIFI (rev. 1.0)...

I upgraded from Yosemite, and also installed Clover. Install basically went well. My configuration is a system with a 120GB startup SSD and a 1TB SATA Hard Drive as the Data drive. So I backed up (through Time Machine) entire system, erased the SSD, and did a clean install of El Capitan and...

Thanks for the suggestion...it basically brought me to this post. I'm not sure why they posted this motherboard as a compatible motherboard without any credible proof that it actually works fully. As far as I can tell, nobody has gotten it to work well. I guess the "rule" is to wait until a...

Would you be able to share your MultiBeast settings? Thx, Rick

Did you have any luck with this MB? Please provide details?

Still no luck on my end, getting it to boot from the drive. Only the USB works

Thanks...my weekend project. I will report back, but thanks in advance!!

My install goes fine. And I can reboot to the USB drive, and use Yosemite where it's installed. However, when I remove the USB and actually try to boot from the SSD where Yosemite is installed, it doesn't recognize the drive. The system is dual boot with both SSD and regular hard drives for...

Yes. Chimera is installed.

I installed Yosemite on my SSD-equipped Asrock X97 Extreme6, 4790K, GTX 760...seemingly no problem, re-booted from USB and utilized Multibeast. The issue I'm having is that when I now remove the USB and try to reboot from my new install, the system doesn't recognize the SSD-based Yosemite...

Based upon the buyers' guide, I purchased ax ASROCK|Z97 EXTREME6 (LGA 1150) -- (noted as the top performer/value on Tom's Hardware), along with a 4790K, etc... I'm looking for anybody who has successfully built with this board. This is my third Hackintosh, and I am having some basic issues...

Thanks for your succinct post. Do you have any idea if these settings/methods will work for Asrock Z97 Extreme6? Haven't been able to get MB to recognize the install (which seemingly went well until I tried to boot from the disk). Thanks in advance for any insights.

Follow up to above...seems to be a MB BIOS issue (I'm guessing). I used the USB UniBeast method to install Yosemite on one of the HDD (not SSD). Asrock will not see it as a bootable drive. Any suggestions?