Recent content by Rotting

Update went fine, but had to include -disablegfxfirmware in boot as suggested at page one. Thanks.

I made up a mess and had to use CCC to restore a backup. But WEG 1.3.4 and LILU 1.3.9 do the job. Works fine now.

Until a few months ago I had the GTX 970. But the issues I had with updates and FCP were driving me nuts. Then I switched to RX580, and it took me much more time time to configure than expected. But halleluja, now I'm trouble free, no more issues with updates and the card is performing much...

Thanks @RehabMan. I should have done this ages ago, but now with 10.14.1 issues I decided to make the effort and yes, success!!!

Maybe Also you should try to boot with recovery disk. That worked for me. Once repaired start up with previous clover plist settings.

That probably will do. What for me worked: in Clover Boot Manager, go to Options -> System Parameters -> System Integation Protection -> unflag Allow Untrusted Kext. After which the code is set to 0x0067. After that boot, install the Web drivers and that's it.

It was a dreadful update but happy to report it works now. Thanks to you all and nvidia!

Same problem here.

Thanks RehabMan. I'll give it another try. And so I did. This time I did a fresh install instead of use CCC to make a copy to the NVMe. I added the HackrNVMeFamily to the USB clover KEXT folder. The SSDT-NVMe-Pcc.aml was already on it. And miracles do exist or at least you're an angel...

I'm working on a build with Z270 Gigabyte Gaming K3 and Samsung Evo 960. Installing Sierra 10.12.4. First I wasn't able to boot. After applying instructions from RehabMan I managed to get the Samsung working. Then I copied Sierra from SSD to SSD Samsung with CCC. Also installed Clover 4049 on...

Update successful. The only problem I had was Clover version v2.3k_r3763. Used v2.3k_r3726 instead.

Updated with the App store. Although it took longer than normal, no issues. Everything works out of box.

Updated without any issues.

UniBeast: Install OS X El Capitan on Any Supported Intel-based PC Hi, I've manually added the dsdt.aml file to the EFI patched folder. After that I was able to get to the installation screen. You did that too? I've attached the dsdt.aml, in case you don't have it. Have you already been...

I'm just wondering, if you have a working Clover bootloader, why don't you install that configuration on your USB? You'll at least get to the installation part?