Recent content by Ranino

I wish that this was the case. When I boot the machine I get clover with 5 options to choose from: Boot Filevault Prebooter from Preboot Boot macOS install Prebooter from Preboot Boot macOS Install from Mojave Boot macOS from Mojave Boor Recovery from Recovery Since the update to Mojave...

Hiya I have been trying to update from 10.14 to 10.14.3 for a while now but without any luck. I even downloaded the combo and installed directly. It just installs, reboots and loads directly into 10.14 all over again. How can investigate what is happening? Thanks!

Hi all, I am already on Mojave (cannot install 10.4.1 patch for some reason but that does not matter now). I would like to install Windows next. I purchased another SSD and plugged it in but I am not sure what Guide to follow now? Thanks! Ranino

Amazing. Solved!

Hi I've literally just installed an update for Sierra because I was a bit lazy to upgrade to High Sierra. No idea what to do here. At all. It just loops around that, reboot and then this again. EDIT: I've researched and it's coming from AppleALC so it seems? EDIT2: I can boot with -x

1. Choose Inject ATI in Clover Configurator 2. https://www.tonymacx86.com/threads/amd-rx-4xx-graphics-cards-in-sierra.202608/#post-1331094 (AMD4100kext)

Yes, all golden here thanks!

I could not get into Clover Recovery HD. I did some reading and found that Fake is not even present in BaseSystem.dmg inside the Recovery Partition. I did not want to deal with it directly because I did not know what damage it may bring. What I have done next is: 1. Load Clover Configurator...

Yes, done that part sure. I worked on a copy. Are there other changes I need to make? You said inject ATI. I have done that before when used MultiBeast in Post Installation. Was that enough? So the first changed (I initially made turned out to be the best, it's just that the card is still not...

Changing only EF to DF did not work. In fact it makes it look weirder on my machine.

I use MultiBeast (I assume clover is inside right? Not something I need to install externally?). When you say "tried the FF or EF definition", do you mean put the 67EO into it's original state and change the FF to DF? Then if that does not work do the same to EF?

I have the same car (just installed a new 10.12.2 machine) I changed the entry in the 4100 kext file, changed ownership of the file too. Nothing. This is what I see AMD R9.

How can I close this? This is now solved.

Sorry. Will update it all now.

Hi I just finished building this machine. Set what I needed in the BIOS. Installation is not happening. I used -v in clover to see the errors. This is what I am getting. Attached screenshot. That's where it is stuck. Help please :-)