Recent content by praneeth22

Upgraded to 10.10.1 still no issues. I also installed VMWare Fusion and mounted my Windows install within Yosemite, which also went smoothly.

Do the logs (with -v) show FakeSMC getting loaded successfully?

As with most Hackintosh installs a fresh install might be the best way to try to tackle this. Then make sure the steps are followed exactly. The hardware you listed other than the graphics card (which I don't know about) Should work. Also confirm your Bios settings are correct.

I did not install USB 3 kexts. They seem to all be working and recognized as a USB 3.0 high speed bus. However I have no USB 3 devices to check functional speed. All ports on front top and back work.

Cool. Same goes for kexts folder, drivers etc btw, they should all be as you want them in the EFI partition.

Make sure the config file you are editing is the one that's being used. If you are using EFI, you have to first mount the EFI partition to be able to see the config file on there. You might be editing the config file for legacy boot and booting off EFI. IF this is the case, to mount EFI...

You didn't install any graphics kexts right? This is just what came with the Yosemite install? From what I see online the Gtx 650 should just work with the built in nvidia kext with graphicsenabler=no. You might also want to try installing the latest nVidia Web driver I think just using the...

Did you install USB 3.0 kexts? That has been the culprit for some who experienced instability. I did not install it and my 3.0 ports seem to be fine with the Apple drivers.

Here's my config file: [REMOVED] I didn't change anything other than the couple of things mentioned in the post though. Hope it helps.

i have not had any unexpected restarts or shutdowns. And no kernel panics either. However, I haven't done much that is graphics intensive. I have three monitors hooked up, two to the GTX 760 Displayport and VGA and a third to the built in board's HDMI port. They all work flawlessly so far...

Detailed Step by Step Yosemite 10.10 Install Guide Clover UEFI / GTX 760 / ALC 898 / Realtek RTL8111 ​I was able to setup two Dell XPS 8700 systems flawlessly with the following steps. Everything except built-in Wifi should work. The systems had stock hardware except for upgraded Nvidia...