Looking for a way to install audio on H55M D2H rev 1.4 (ALC888b) with Clover. Have tried running the ALC command as well as the MultiBeast method with support for EFI bootloaders. Neither seem to be working. Help? :(
Clean installed 10.10.0, haven't updated, the problems persist. I'm dead sure this wasn't happening about 3 months earlier when I was on 10.10.0, so either something has changed in ProBook Installer that is now triggering this issue, or this is a hardware issue altogether. Could this be an HDD...
Nope. Tried everything. EC reset. Fresh 10.10.0 install, then updating to 10.10.2. Also tried a fresh 10.10.2 install. Tried removing each ram module to eliminate that. Checked hard drive through HP system diagnostics. Nothing works. Will be most likely shifting to Windows, since these freezes...
Yup. Updated to F60a. Still freezing.
--------
Edit: the issue may have been resolved after installing support kexts from new PBI CE. Haven't seen freezes till now. Will update in case it happens again.
--------
Edit 2: Welp, they're back. Going to do a fresh install and stick to 10.0.0 if...
What's the best way to find out which one I am using? I checked S/L/E, shows only IOa3tkfrmwr.kext and not BTfirmwareuploader.kext. Just figured, the freezes get longer and more frequent after waking from sleep. These messages on Console (attached screenshot) correspond to the freezes, as far as...
I'll try repatching DSDT again. Sorry, I'm not too well acquainted with the hardcore coding or backend bit of it, so I usually follow the guides from top to bottom. So I'm not too sure what you mean by bluetooth firmware uploader, doubt I used one, as far as I know. I used the PBI CE guide given...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.