Specification
CPU : i5 3470
MB: z77P-D3
SSD Vertex4 128GB
Graphic : HD6850
Mountian Lion 10.8.2
sometime it got kernal panic on start up. I've to restart again to boot system . I dont know why
Beside of this problem everything work fine . this problem just a bit annoy me
I...
I use vertex4 and I heard that Vertex4 have a Garbage Collection and it act like Trim Enabler so we shouldn't use trim enabler because they've same duty
but my hac was slow Read/Write data on disk speed test
maybe should I enabled trim enabler ?
let's me guess you have to set graphic enabler to "No" then you can boot in to ML
and when you can get in to ML you have to set frame buffer
go to folder Extra > org.chameleon.Boot.plist
use this flag <key>AtiConfig</key>
<string>Bulrushes</string>
<key>AtiPorts</key>...
My method is very simple
1.delete AppleHDA.kext from System/Library/Extensions/AppleHDA.kext (just command+delete)
2.restart
3.run Kext Utility wait till finished
4.install VoodooHDA 2.7.3 from Multibeast
5.Restart
finish :thumbup:
but have few problem
1.sound quality not quite good...
Re: USB3 didn't work Z77M-D3H
Big Thank thelostswede!!!!!
Like you said I did something wrong that is xHCI
have to change to Auto mode and USB3 can WORK!!!!
Thank You Very Much!!!! :thumbup:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.