Recent content by Necrouk

Ah.... I see, thanks for the information, that makes things a bit clearer to what I was trying to do then. My issue is that the 2 Kext files I installed dont give full acceleration for my card (acts lick it is in safe mode) very laggy etc. There was a thread where a guy was adding information...

Hi, Installed Yosemite and after a lot of playing around (very non tech noob) I got it to work not just in safe mode by installing these two Kext AMD7000Controller.kext and AMDRadeonX4000.kext I didnt modify them as I dont know how to, so are as I got them. It now boots to desktop not in safe...

Jithin.C.V Can you please help? :-)

Could you supply the correct files for me please :-) AMD Radeon R9 270X: Chipset Model: AMD Radeon R9 270X Type: GPU Bus: PCIe PCIe Lane Width: x16 VRAM (Total): 6 MB Vendor: ATI (0x1002) Device ID: 0x6810 Revision ID: 0x0000 EFI Driver Version: 01.00.3180 Displays...

I have replied to the above using safeboot, graphics and audio seem the main issue. Can I do something to stop it using SafeBoot?

If I do thirds will it overwrite the other settings? The internal drive is an ssd but has not had trim enabled. This was the disk used to clone. Thanks

No errors found during check.. Rebooted same thing :-(

Hi, been away for a bit. I used the dd command as advised by another forum member and still get the same issue, automatically using SafeBoot on every start. I even cloned the drive sector by sector with Active@Bootdisk as a raw sector copy onto a brand new drive. Copied fine no errors. When...

Its not :-(

I was worried it might be the case about the drive sizes... So I have tried this.. cloned the working drive, used multicast but this time selected easydsdt. It boots into the desktop without any errors, but its always booting in Safeboot, I am not choosing this with a command, its doing it on...

Sounds just what I am looking for, as I am guessing something is not being copied.. I was tempted to try a program to do a raw copy like acronis in Windows.. Will try in a bit. Thanks :-) Do the drives need to be the same size? Or as long as there is enough space on the ssd for the data on...

Just looked now and those files do not exist on the ssd... :-(

The ssd was connected for the cloning and multibeast part by a usb cradle. I have tried booting both in the cradle (USB) and connected on the pc via sata (replacing working disk). Same error screen each time. With 3 different disks 2xsata hdd and 1xssd.

Hi, firstly sorry its on 2 threads, I thought these guys where going to be a good place to start with the problem. I have tried booting via usb and also by swapping it with the working hdd on sata. Thanks

Thanks for the reply.. I did try that after reading another post -x and -f is that correct. No different. It seems like the drive is booting, but then not seeing the drive, as if its changing how it access the drive at that point. I have tried this on 3 different drives, 2 hdd and 1 sdd all...