Recent content by nandystam

  1. nandystam

    [Guide] HP Folio 13 Guide (Yosemite/Mavericks)

    OK. Last one, as I'm using Clover rather than Chimera, I don't need to install a patched AppleIntelCPUPowerManagement? From reading various things it seems Clover handles the patching automatically via the AICPUPM and KernelPM KernelAndKextPatches (which are both enabled) ? Otherwise, I'm good...
  2. nandystam

    [Guide] HP Folio 13 Guide (Yosemite/Mavericks)

    Ok so using Clover things went much better! Both USB ports are working fine with AppleUSBXHCI. I still need to patch a few things but everything I had working before is still good now. So thanks for the suggestion. One thing I'm not sure about, the 3rd Party SATA kext (via Multibeast) mentioned...
  3. nandystam

    [Guide] HP Folio 13 Guide (Yosemite/Mavericks)

    Will give it a go and report back.
  4. nandystam

    [Guide] HP Folio 13 Guide (Yosemite/Mavericks)

    I got 10.10.5 from the app store, and used UniBeast 5.2.0 on a 2011 iMac to create the USB installer. Is it possible to resolve this with Chimera or would I need to use Clover?
  5. nandystam

    [Guide] HP Folio 13 Guide (Yosemite/Mavericks)

    I have been following this guide on a HP Folio 13-2000 and have everything working in 10.10.5 (including rebranded wifi), but the left USB port (which is the USB3.0 one) is unfortunately not working. I have seen some other people have had a similar issue. I was using GenericUSBXHCI.kext but as...
  6. nandystam

    [Guide] HP ProBook/EliteBook/Zbook using Clover UEFI hotpatch (10.11)

    So far no issues. Will report back if I see anything unusual. Thanks!
  7. nandystam

    [Guide] HP ProBook/EliteBook/Zbook using Clover UEFI hotpatch (10.11)

    I used SSDT-USB-840-G2.aml, booted with -uia_ignore_rmcf and ran the test again. IOReg output attached. Fingers crossed I did everything correctly.
  8. nandystam

    [Guide] HP ProBook/EliteBook/Zbook using Clover UEFI hotpatch (10.11)

    Apologies, I've updated that information now. I've re-attached the ioreg output to this post, so hopefully second time around I can get a custom USB SSDT created since there isn't one for this particular model? Thank you :)
Back
Top