Thank you! Updated Clover and I was going nuts about this black screen at boot, and after i restored the file, I am able to boot again.
Before I found this solution mentioned above, during my troubleshooting, I removed the following files: AppleKeyFeeder, SMCHelper-64, VboxHfs-64.
Today I opened the Audio Midi Setup, Highlighted the Astro Wireless transmitter tab, Output, Configure Speakers and changed the setting from Stereo to 2.0 Surround.
Been using the headset for hours, in fact, this is the longest that i have used them without incurring Static Noise.
This has been an ongoing issue. I've experienced this since Mav. My quick solution is to change the sound output to the HDMI and then select back the Astro. But unfortunately, the symptoms come back within a few minutes.
I read the specs, they mention Sata 6gb and that's what I used. On their website there is a mandatory firmware update. I can follow instructions pretty good, however OCZ put out the worst guide on how to update that firmware.
I purchased 2 SSD and didn't even bother to open and try with the...
True, i must have ignored that when I try to compile the DSDT i get: 10396, 6085, Object not found or not accessible from scope (_SB.PCI0.PEG0) 10396, 6116, Forward references from Scope operator not allowed (_SB.PCI0.PEG0)
However PEG0 is present. !?!?!
Using Clover 10.10.4, sabertooth z77, 3570k, ssdrPRgen, im able to generate the following ssdt, however it crashes when boot-up. I have attached the config.
ssdtPRGen.sh v0.9 Copyright (c) 2011-2012 by † RevoGirl
v6.6 Copyright (c) 2013 by † Jeroen
1. I get no HDMI audio device.
2. OS X 10.10.4 / Sabertooth Z77 / 3570k / EVGA GTX 970 SSC
3. 1st attempt at clover/yosemite, with HD4000, didn't have Audio Devices, was able to enable audio devices by using "audio_cloverALC-110.command, and no HDMI audio. Then I got a EVGA GTX 970...