Recent content by moabyte

Yes, the Prime Z790 is a great board. I also like this build, https://www.tonymacx86.com/threads/asus-z690-proart-creator-wifi-thunderbolt-4-i7-12700k-amd-rx-6800-xt.318311/ I think there is now a 790 version of this board. And this one, which I just built. Asus ROG Strix Z690-i Gaming WiFi...

I second the use of ASUS or Gigabyte MoBo. Also, go with a DDR5 board, the ram is much faster.

Bluetooth and wifi connectivity are set to Enabled in BIOS. I've ordered another wifi/BT card, I think this one has bad wifi. I can't think of anything else it could be, unless its the screw issue I've come across.

Yes, VT-d is enabled in BIOS.

Got the Audio working, thanks for showing me what port its on. As for the Wifi, I do have both the kexts above disabled and removed from the EFI kext folder. I also removed the BlueToolFixup.kext. BT is working great, WIFI still shows and exclamation over the icon in menu bar. Thanks for...

@CaseySJ Thank you for an excellent write up. I just finished a build with this board and installation was easy and smooth. Used OC 0.9.3. Monterey and Ventura both installed fine, but stayed with Monterey. Geekbench scores were very low under Ventura, like half. Not sure what that was about...

Just helped a friend order all the parts for this build, but with the same MB Stamy is using, ASRock H670M-ITX/ax and and i9 processor with water cooling. Wish me luck on my build this Saturday. Look like a winner.

A quick update: I changed my system ID to iMac 18.2 and updated to Ventura without issue and everyting is working great. I first updated the OC to the latest and ran the update via the system update. I was also able to perform a clean install to a blank drive. I'm getting really good...

I got it running. If you have a VPN, turn it off, it does not like a VPN. LOL

Installing mini conda got me through the errors. I said no to the model install and entered the token, it completes the installation, but I can not launch the web-UI.

I tried that, and saying yes to the model, both end with errors

OK, I have managed to get the script to install, but it gets to the model part, I select N, enter the tocken and then it errors. What am I doing wrong here?

Performed a smooth upgrade to Monterey. Had a few quirks with USB and audio, but was quickly able to find the solutions to get them going again. All working 100%.