Hello
I’m not sure if this is the right place to ask, but I tried to look for an answer but no luck.
After successfully installing 10.14.5 (everything is working perfectly except sleep) I got a new SSD to install windows to.
I’m having all sort of problems with windows !! USB randomly...
installation went smooth. audio and Lan working directly.
just a quick question about Multibeast.
Do i have to reflect all the settings done in clover in Multibeast again ?
Damn THAT WORKED !:headbang::headbang:
i disconnected LAN (as @orbec recommended) and used your config !
now I'm inside the installer
i hope this completes installation
thats not mentioned in any BIOS guide !
will do that
edit : Disabled Serial Port under : Super IO Configuration
still getting the same panic ( tried 2 times )
i have a theory and it might be totally wrong.
when the PC goes to black screen it feels like it still running , it doesn't reboot.
is it possible (since the Mobo Has 1 HDMI + 1 DVI) the installer is confusing the two ? and using DVI ?
thanks for the reply. i'll try that right away
Just to be clear in BIOS . Initial Display out put should be iGFX ?
or it doesn't matter since the dGPU is disconnected ?
I have followed the BOIS settings as recommended in Z390 Guide (gigabyte) (for some reason my bios was reset ! so i did it again to make sure) (+ initial GPU = iGPU)
here's the screenshot (taken from a video) just before the screen goes back ! + EFI
thanks in advance
at the same point i attached earlier (i had to shoot a video and stop it to see).
thats really bad news about this Mobo :(
its the first one on the parts guide (mATX)
do you think i should forget it !?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.