I'm trying to update clover to r4411. When installing it to my ssd, it says installation succesful but when checking the clover version in clover configurator it stays I'm still on an older version.
I've waited for more than 1 hours, and nothing happened. To be more precise, at the end of phase 1 the screen turned off and a few minutes later the fans started to turn very fast. I wasn't able to read what verbose mode said since the screen stayed on for less than 1 second.
I think that the...
The screen become black at the end of phase 1 and doesn't reboot, should I wait ?
When running the installer again shouldn't I boot macos install ?
What do you mean by the option available in clover ?
Thanks for your help
I've done what you said but again, same issue. At the end of phase 1 the screen become black and nothing happen, when rebooting and continuing the installation it fail at the beginning.
I've tried that, it is still not working it crashes at the end of phase 1. Maybe there is somethings missing in my clover folder but I can't figure it out.
I deleted my windows partition, same issue, at the end of phase one instead of rebooting the screen become black. Also in your guide you said that it will stay a long time at 1 minute remaining but it isn't the case.
So I followed your guide from scratch and only yours, I successfully booted the installer, and at the beginning of phase 2, it stops. I'm trying to dual boot while preserving my windows partition so maybe that's what is wrong. I attached my clover file and the installer log, could you please...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.