Recent content by Majko

I've created the installation USB again, with other UniBeast version (the latest, I've noticed I had some older version) and it works now. I'll leave this here, if anyone will have the same problem

Hello dear hackintoshers, I'm trying to install latest macOS on my hackintosh and I ended up with "Cannot be installed" error when selecting the target disk for instalation. I've used UniBeast for creating the bootable USB, using latest macOS from App Store. I had to use -no_compat_check boot...

I stumbled upon this video Have anyone tried this? Does it work? Does it mean we can finally run Hackintosh with Polaris GPUs on mobos without iGPU? If not, is there someone who can confirm if it works or not? (Currently, I don't want to spend hours Hackintosh-ing just to find out it...

Also, I would like to send a few thanks to Gigamaxx, I appreciate your activity here around, seen your posts and accurate answers to all kinds of questions here. Thanks, dude.

Only gtx460, will it work too? And does it mean the rx480 will never work on it's own? :/

So there is no chance to make rx480 working in macOS, if I don't have mobo with igfx support? That's disappointing, bought rx480 instead of gtx1060 just because of being sure it will work with macOS. :/

After reverting the AMDRadeonX4100.kext to the original state (thus removing the ID from Info.plist), I have now at least working system without the acceleration. :(

Well I'm not sure which one is my first slot, but I'm using the top-most pcie slot on my mobo. And I haven't even tried to use the last piece of code, since you said "only half of them will be used", I choosed to make it working first without all cores and if it's working, add this piece of...

Unfortunately this does not seem to be working. I can hear the GPU making the hiss sound, but then no signal output. I was able to run macOS without acceleration, but now, even if I put all the config to the state I used it with before (remove fakeID, not injecting EDID, not acpi patching...