Recent content by Mace

Hi, StefanAM: Can you test whether the video output is normal? I have tried many TB3 AIC with Alpine-Ridge architecture. After refreshing the firmware, there is no video output, but the docking station is normal

Yes, but I'm not using custom memory

Hi, CaseySJ I upgraded the memory in my X99 build. It can reach 3200Mhz with XMP frequency. It is normal in Windows, but the system information is displayed as 2933Mhz in macOS. Is it OpenCore recognition error or automatic downfrequency in macOS memory?

Thanks, 2.0.1 will work fine now

Hi Inqnuam, I used HackinDROM Beta 2.0 in Big Sur 11.6 and nothing changed in the status bar when I opened it. I couldn't find the HackinDROM icon

Hi CaseySJ, I previously reported that the audio controller could not load normally when VT-d was enabled in my system (GA-X99-Designare-EX). I solved the problem by modifying the DMAR table. and now it works well without any problems, Ethernet and WiFi and Audio working. Attached is the...

Hi @CaseySJ My MSI-B460m-MORTAR was installed with Thunderbolt 3 AIC and plugged into a USB device, which caused the system to crash. I tried ASUS Thunderbolt 3 and MSI Thunderbolt M3 AIC in Alpine Ridge. But under Windows there was no problem, the Thunderbolt device was not tried, and the...

Hello, CaseySJ When I enable VT-D in my Gigabyte X99 Designare EX (Intel HEDT), the onboard sound card will not work. Memory 4 slots are occupied with 8GB DIMMs each (total 32GB) I found that Broadcom's Gigabit Ethernet would not work properly without VT-D enabled in Big Sur

No, the GPU only injected the "model" property and built-in, and the sound controller only injected the layout id in the boot args

Thank you very much for your help. After the replacement, there is still no change. I found that there is such a thing in the PCI device. It doesn't seem to be loaded.Does it have an impact on this? In addition, I found that the GPU audio device is not loaded, this is my IOReg and DSDT.

iMac Pro 1,1

Hi @CaseySJ ! I opened VT-d in the BIOS and deleted the memory area of the DMAR table according to your guide. After entering the system, I saw that "AppleVTD" has been successfully loaded. Since upgrading Big Sur, the network card (BCM57762) of my Thunderbolt 3 docking station has been...

:crazy: I was so stupid. It went to sleep again about 1 minute after it was automatically awakened. Now the problem is solved. I'm sorry to disturb you.

@CaseySJ, Hi Casey, My Hack always wakes up automatically halfway through sleep. After checking the "Wake Reason", the question mark "?" is displayed. I used Hackintool to check the system log and found that Thunderbolt HAL might be the cause of the wakeup? 2021-05-30 11:32:26.009006+0800...

Hi CaseySJ, Thank you for your follow-up. Unfortunately, after flashing MOD2, it appears the same result as MOD1. I was wondering if we could go back to SSDT(TbtOnPCH). I don't know if it is related to CH341A, my CH341A often fails to flash firmware, I have ordered Raspberry Pi 4, I hope to see...