Recent content by Katliner

  1. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    Hi. This patch exists to recognize the keyboard. If your keyboard works without a patch on your laptop, you don't need this patch.
  2. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    There was an article that the 10th generation CPU needed to disguise the PCI ID to produce sound. Z490 sound seems to be supported in OpenCore 0.6.0, so please try updating OpenCore and AppleALC.kext. Also, the graphics are for Intel UHD Graphics 620 so please use Hackintool to generate the...
  3. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    Ah... sorry. I'm not sure because that doesn't happen. Also, I do not have much knowledge...
  4. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    The built-in microphone works by introducing Lilu.kext and AppleALC.kext and setting the Layout ID. I used 11 this time, but other IDs can be used. Brightness works by introducing WhateverGreen.kext, SSDT-PNLF-CFL.aml and adding information about the graphics board in config.plist. The Intel UHD...
  5. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    Set SMBIOS using OpenCore Configulator or macserial. How did you configure DSDT? Can you give me instructions?
  6. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    When I checked it, I heard that the sound was only emitted from the upper speaker. The left and right speakers don't seem to be used. I didn't notice until now.
  7. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    It may be possible to write a patch for the brightness key in SSDT, but the patch that enables the PS2 keyboard must be written in DSDT, so DSDT is eventually required. PS2 keyboard patch does not work with SSDT.
  8. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    sorry. I forgot to rewrite the patch file. I uploaded a newly rewritten version. I tried it and it worked the same on both 4F and 6B. I'm not sure, but I'm happy because it worked.
  9. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    I haven't used HeliPort because I need to configure it again when Laptop restart. What about you?
  10. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    TPD0 was 6b.So I looked here and confirmed that it was GPP_D11_IRQ. Next, I looked here and confirmed that it was 79. Since 79 is dex, it is 0x4F when converted to hex. So I used 0x4F for GPIO Pin.Similarly, since TPL0 was 23, the GPIO Pin is 0xB. Thank you so much for your advice! I changed...
  11. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    thank you for the advice. I created a DSDT patch for the battery. As a result, the battery level indicator now works properly. The difference between Windows and macOS is 1-2%. But the trackpad doesn't work at all. Apparently GPIO pinning seems necessary, I specified 0x4F but it didn't work...
  12. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    I switched from Clover to OpenCore. OpenCore was the first attempt, and it was very difficult. However, it is now bootable. But I2C, battery and Bluetooth don't work well. I have confirmed that GPIO pinning is not required. I'm still adjusting. I don't think the webcam works. There may be some...
  13. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    Thank you. I will make a patch for DSDT based on that information.
  14. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    Wow. That's good. I will try it on OpenCore when I have time. I will report the results after trying.
  15. Katliner

    [GUIDE]HP Spectre x360 13-ap0037TU(Late 2018)

    Thunderbolt 3 is working very well. I was able to output the video. I tried it once with OpenCore, but it didn't start up successfully. In the first place, I have little experience with OpenCore and have never worked well. I was looking for a touch screen driver but none were suitable...
Back
Top