I have a very good working hackintosh configuration. But I have a little problem.
My Wi-Fi card is : TP-LINK TL-WDN4800 with AR93xx chip.
The card has been natively and promptly recognized by the system since the installation process.
The points are :
1)the card does not...
I recently installed El Capitan with Unibeast on my configuration and everything appears to work just fine.
There's just one problem.
I can't make audio work! My Audio codec is : AD1988B
I tried several DSDT and AppleHDA patches but nothing appears to be working.
For now I have...
Clover Very Slow to start up
Yes my OCZ is attached to an Intel SATA controller.
However I found a solution!!!
SOLUTION : Just install CloverEFI bits BiosBlockIO instead of traditional CloverEFI 64 SATA!!!
It boosted my boot time from 30 seconds to 2/3 seconds!! Just what I wanted!! :)
Clover Very Slow to start up
Thank you for your answer.
I made the changes to the BIOS you suggested but nothing has changed, but I noticed something more.
Before the little dash in upper left corner, it says boot0f or something like that and it should be clover that it's been...
I installed El capitan on my machine using unibeast 6 and it seems to work very very well except for two things : audio (AD1988B, not even seen by the OS, and so I'm using nVidia HDMI audio, but that's another story) and a strange sluggish thing at boot.
The PC takes around 4 seconds...
Thank you for your answer!
I made several tries and I can confirm that IT WORKS!!!
I just applied DSDT fixes (mask 0x000000105B) that worked for X58 chipset on my configuration and it worked very well!
So I can confirm that the method used for X58 chipset is ok for P35 chipset as well...
I have the exact same issue and I have system specs written in my profile.
I get this exact kernel panic and my computer restarts.
I cannot rebuild USB kernel cache as well.
Please help me if you can.
I made some researches and it seems to be a well known error.
I have a P35 chipset, not X58 (that has a better solution for that error).
Please, could anyone tell us, how to rebuild the kernel cache for the external USB installer??
Because I wanted to try to boot deleting the kext but it...
I have the exact same problem!!
Many users reports that it can be solved by deleting the kext inside IOUSBHost kext. But I can't rebuild the USB device kernel cache and so I have always the same error even when deleting the kext.
Please help if anyone can.
My hardware is the one in my...
I contacted EmylDinesh the author of the topic itself on the other forum you suggested to me but unfortunately he couldn't enable it as well...VGA port is detected but the display has no signal...and I understood that he's not willing to continue the project..
I'm not enough experienced to do...
Yes...but I bypassed nvidia optimus engine via BIOS and I could totally disable intel gpu.
Hence my OSX recognize the card correctly (I can see it from system properties using VNC monitor)...so the drivers are actually working.
There is just something missing...some information about...
Thanks! I edited the post and deleted the mail address.
However I'd be thankful to anybody who would join me to make mobile kepler nvidia cards to work under osx.
I am so close to that target!
I got it working with VNC display. It just cannot recognize laptop ports but the drivers are...